Abstract:Cyclic loads generated by environmental factors, such as winds, waves, and trains, will likely lead to performance degradation in pile foundations, resulting in issues like permanent displacement accumulation and bearing capacity attenuation. This paper presents a semi-analytical solution for predicting the axial cyclic behavior of piles in sands. The solution relies on two enhanced nonlinear load-transfer models considering stress-strain hysteresis and cyclic degradation in the pile-soil interaction. Model parameters are calibrated through cyclic shear tests of the sand-steel interface and laboratory geotechnical testing of sands. A novel aspect involves the meticulous formulation of the shaft load-transfer function using an interface constitutive model, which inherently inherits the interface model's advantages, such as capturing hysteresis, hardening, degradation, and particle breakage. The semi-analytical solution is computed numerically using the matrix displacement method, and the calculated values are validated through model tests performed on non-displacement and displacement piles in sands. The results demonstrate that the predicted values show excellent agreement with the measured values for both the static and cyclic responses of piles in sands. The displacement pile response, including factors such as bearing capacity, mobilized shaft resistance, and convergence rate of permanent settlement, exhibit improvements compared to non-displacement piles attributed to the soil squeezing effect. This methodology presents an innovative analytical framework, allowing for integrating cyclic interface models into the theoretical investigation of pile responses.

Advanced laboratory investigation of axial cyclic loading in silica sands

Stress Paths Measured Around A Cyclically Loaded Pile In A Calibration Chamber

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Theoretical Breakage Mechanics and Experimental Assessment of Stresses Surrounding Piles Penetrating into Dense Silica Sand

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Field and Model Investigations into the Influence of Age on Axial Capacity of Displacement Piles in Silica Sands

Stresses Developed Around Displacement Piles Penetration in Sand

Interpretation of Stress Measurements Made Around Closed-Ended Displacement Piles in Sand

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Centrifuge Modelling of Lateral Cyclic Behaviour of a Tetrapod Piled Jacket in Soft Clay

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Performance of laterally loaded H-piles in sand

Experimental Study on Vertical and Lateral Behaviour of Open Caisson Foundations in Clay

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Model tests of single pile vertical cyclic loading in calcareous sand

Numerical modeling of centrifuge cyclic lateral pile load experiments

Theoretical investigation on axial cyclic performance of monopile in sands using interface constitutive models

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles