Abstract:The angle of repose and characteristics of the base stress distribution underneath granular piles serve as essential indicators in understanding the mechanical and packing properties of particle system. One counterintuitive phenomenon is that there is an evident dip of the base stress beneath the pile apex that might have implications in the design of granular pile facilities. The repose angle and stress dip are influenced by many categories of factors and exhibit different variations. Based on the localized source method, particle packing experiments were conducted to investigate the effects of funnel height, particle size, particle shape, and packing method on the repose angle and the vertical stress distribution of granular piles. The experimental results show that the repose angle of piles of irregular particle shape and higher funnel height is much larger, but there is a decreasing trend of repose angle with increasing particle sizes. The natural packing angles before and after the critical collapse of granular pile exhibits periodic variation. On the other hand, the stress dip phenomenon occurred in all granular piles constructed by localized procedure. An increase in funnel height and a middle particle size mitigate the stress dip to some extent, whereas irregular particle shape exacerbates it. Comparison of the results from different packing methods reveals that larger repose angle and more pronounced stress dip are observed in confined packing piles compared to that in free packing piles. Considering a growth rate of less than 5 %, the average vertical stress under the sand silo reaches saturation state. Moreover, the pressure on the silo wall increases with the height of silo pile but remains somewhat lower than predicted by the Ketchum equation and current design values.

Stresses Developed Around Displacement Piles Penetration in Sand

Theoretical Breakage Mechanics and Experimental Assessment of Stresses Surrounding Piles Penetrating into Dense Silica Sand

Interpretation of Stress Measurements Made Around Closed-Ended Displacement Piles in Sand

Discussion of "stresses Developed Around Displacement Piles Penetration in Sand" by Z. X. Yang, R. J. Jardine, B. T. Zhu, and S. Rimoy

Sand Grain Crushing and Interface Shearing During Displacement Pile Installation in Sand

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

Advanced laboratory investigation of axial cyclic loading in silica sands

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Field and Model Investigations into the Influence of Age on Axial Capacity of Displacement Piles in Silica Sands

Three-Dimensional DEM Simulation of Plugging Behaviour of Small-Diameter Open-Ended Model Piles Penetrating Into Sand

Experimental Study on the Development of Surrounding Soil Stress During XCC Pile Installation in Sand

The Angle of Repose and Base Stress Distribution of Granular Piles: an Experimental Investigation

Performance of laterally loaded H-piles in sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Material point method simulations of displacement pile and CPT penetration in sand considering the effects of grain breakage

Installation of open-ended piles: A numerical investigation into the effects on the state of silica sand