Abstract:Huge and critical structures, such as fuel storage tanks and nuclear power plants, are often built on dense sandy grounds, which may cause excessive plastic deformations under multidirectional cyclic shearing conditions caused by earthquakes. The lack of investigation of sand behavior under multidirectional loading may lead to unsafe designs, and thus significantly increase the maintenance cost for infrastructures during their long operational time, which might be longer than 100 years. This study presents a numerical investigation on the liquefaction behavior of dense sand under bidirectional cyclic simple shear using the discrete element method. The bidirectional cyclic simple shear tests with varying stress trajectories on the deviatoric stress plane, including figure-8, circular, and straight lines, were conducted. Additionally, a series of unidirectional loading tests was conducted in the simulation scheme for comparison purposes. The effect of the initial static shear on the cyclic behavior and liquefaction resistance of granular materials was examined. Four loading categories, including full reversal, partial reversal, intermediate reversal, and no reversal, were implemented in the numerical simulations. Although the presence of the initial static shear may enhance the cyclic resistance of granular samples under unidirectional loading, it mitigates the liquefaction resistance and promotes the failure of specimens under bidirectional shearing conditions. The microscopic analysis was performed to reveal the relationship between the fabric evolution and external loading, which can provide profound insights into the underlying mechanism of the cyclic behavior and liquefaction susceptibility of granular material when both the bidirectional shearing and initial static shear effects are considered.

Sand Grain Crushing and Interface Shearing During Displacement Pile Installation in Sand

Stresses Developed Around Displacement Piles Penetration in Sand

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Theoretical Breakage Mechanics and Experimental Assessment of Stresses Surrounding Piles Penetrating into Dense Silica Sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Advanced laboratory investigation of axial cyclic loading in silica sands

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Field and Model Investigations into the Influence of Age on Axial Capacity of Displacement Piles in Silica Sands

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Performance of laterally loaded H-piles in sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Material point method simulations of displacement pile and CPT penetration in sand considering the effects of grain breakage

The Angle of Repose and Base Stress Distribution of Granular Piles: an Experimental Investigation

Shear Band Between Steel and Carbonate Sand Under Monotonic and Cyclic Loading