Abstract:A set of tests with the hollow cylinder apparatus are conducted to simulate the oblique incident seismic waves. Tests are performed with two cyclic stress components involving the horizontal shear stress (torsional shear stress) and the vertical shear stress (stress difference between vertical normal stress and horizontal normal stress) to show an elliptical shape in the orthogonal coordinates of stress difference and shear stress. Then the dynamic characteristics of saturated Fujian standard loose sand, consolidated under isotropic undrained condition and applied with cyclic oblique elliptic stress path, cyclic circular shear, cyclic torsional shear and cyclic triaxial path, are studied. The experiment results show that the development of elastic pore pressure can be classified as "sharp dropping type" and "sharp rising type". The cumulative rates of excess pore water pressure under cyclic circular shear and under cyclic torsional shear are the fastest and the slowest respectively. The normalizing pore pressure is independent of inclination angle of the obliquity of elliptic path, but depends on the ellipticity of cyclic stress path and stress amplitude CSR. Experimental results also indicate that undrained dynamic strength of Fujian sand is closely related to cyclic stress path. The cyclic torsional shearing path and cyclic triaxial path have the highest dynamic strength. The strengths under standard inclined elliptical loading path and under cyclic circular path are lower and the lowest respectively. Approximate circular path can be generated with seismic wave in a particular incident angle. If seismic wave is regarded as vertical incident S wave, the soil liquefaction strength would be overestimated.

Interpretation of Stress Measurements Made Around Closed-Ended Displacement Piles in Sand

Stresses Developed Around Displacement Piles Penetration in Sand

Theoretical Breakage Mechanics and Experimental Assessment of Stresses Surrounding Piles Penetrating into Dense Silica Sand

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

Advanced laboratory investigation of axial cyclic loading in silica sands

Stress Paths Measured Around A Cyclically Loaded Pile In A Calibration Chamber

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Discussion of "stresses Developed Around Displacement Piles Penetration in Sand" by Z. X. Yang, R. J. Jardine, B. T. Zhu, and S. Rimoy

Sand Grain Crushing and Interface Shearing During Displacement Pile Installation in Sand

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Field and Model Investigations into the Influence of Age on Axial Capacity of Displacement Piles in Silica Sands

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Experimental Study on the Development of Surrounding Soil Stress During XCC Pile Installation in Sand

Material point method simulations of displacement pile and CPT penetration in sand considering the effects of grain breakage

A Destructive Field Study on the Behavior of Pile under Ten

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Installation of open-ended piles: A numerical investigation into the effects on the state of silica sand

Stress Propagation and Arching in Static Sandpiles