Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Development of CO2-integrated 3D printing concrete

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Properties and Microstructures of 3D Printable Sulphoaluminate Cement Concrete Containing Industrial By-Products and Nano Clay

Study of 3D printed concrete with low-carbon cementitious materials based on its rheological properties and mechanical performances

A novel method for improving the printability of cement-based materials: Controlling the releasing of capsules containing chemical admixtures

Modification effect of nanosilica and polypropylene fiber for extrusion-based 3D printing concrete: Printability and mechanical anisotropy

The synergistic effect of greenhouse gas CO 2 and silica fume on the properties of 3D printed mortar

A review of 3D printed concrete: Performance requirements, testing measurements and mix design

The relationship between the rheological behavior and interlayer bonding properties of 3D printing cementitious materials with the addition of attapulgite

Effect of Nanostructured Silica Additives on the Extrusion-Based 3D Concrete Printing Application

Strength and Proportioning Design of 3D Printed Concrete (3DPC) Based on Aggregate Gradation Optimization

Carbon dioxide as an admixture for better performance of OPC-based concrete

Effect of supplementary cementitious materials on properties of 3D printed conventional and alkali-activated concrete: A review

Incorporating coarse aggregates into 3D concrete printing from mixture design and process control to structural behaviours and practical applications: a review

Inclined 3D concrete printing: build-up prediction and early-age performance optimization

Effects of oyster shell derivatives on performance enhancement of biomass-based 3D printed concrete

Exploring carbon sequestration potential through 3D concrete printing

Solid waste-based set-on-demand 3D printed concrete: Active rheological control of cement-based magneto-rheological fluids

Optimization of Foams—Polypropylene Fiber-Reinforced Concrete Mixtures Dedicated for 3D Printing

Thermally stimulated stiffening and fly ash's alkaline activation by Ca(OH) 2 addition facilitates 3D-printing

Development of concrete mixes for 3D printing using simple tools and techniques