Normally-off hydrogen-terminated diamond field effect transistor with yttrium gate

Minghui Zhang,Wei Wang,Shuwei Fan,Genqiang Chen,Haris Naeem Abbasi,Fang Lin,Feng Wen,Jingwen Zhang,Renan Bu,Hong-Xing Wang
DOI: https://doi.org/10.1016/j.carbon.2021.01.121
IF: 10.9
2021-05-01
Carbon
Abstract:<p>—The normally-off Yttrium (Y) gate hydrogen-terminated (H-terminated) diamond field effect transistor (FET) with 5 nm Al<sub>2</sub>O<sub>3</sub> dielectric layer has been successfully fabricated and evaluated in this work. The threshold voltage is extracted to be - 0.21 V at drain source voltage of -10 V, and the normally-off mode should be caused by the low work function of Y. The <u>saturated drain current (I</u><sub>DSsat</sub><u>)</u> <del>maximum drain source current (I</del><sub>DSmax</sub><del>)</del> is - 16.14 mA/mm obtained at gate voltage (V<sub>GS</sub>) of - 2.5 V with 4 μm gate length and 100 μm gate width. The value of <u>I</u><sub>DSsat</sub> <del>I</del><sub>DSmax</sub> is relatively high compared with other normally-off H-terminated diamond FETs at the same gate voltage, and this is ascribed to the well-preserved two-dimensional hole gas channel. The maximum transconductance of the fabricated device is 7.97 mS/mm. The current on/off ratio is about 7 orders of magnitude with a subthreshold swing of 150 mV/dec. The maximum effective mobility is 233.08 cm<sup>2</sup>/Vs. The results contribute to the development of normally-off H-terminated diamond FETs significantly.</p>
materials science, multidisciplinary,chemistry, physical
What problem does this paper attempt to address?