Abstract:This paper investigated the bonding mode and atoms' surface energy in the α-Fe and NbC bulk phases in NbC/Fe composites using the first-principles calculation of density functional theory. Different interface models were established to evaluate the interface bonding strength and stability considering the total interface energy and work of adhesion. After structural optimization, four interface models were established, α-Fe(100)/NbC(100) at the C-terminus, α-Fe(100)/NbC(100) at the Nb-terminus, α-Fe(100)/NbC(111) at the C-terminus, and α-Fe(100)/NbC(111) at the Nb-terminus, defined as interfaces I, II, III, and IV, respectively. The results show that the interface adhesion of the C-terminal interface is higher than the Nb-terminal interface. The minimum total energy of interface I and the maximum adhesion work are − 1.80 × 10 4 eV and 5.31 J/m 2 , respectively, indicating the most stable interfacial bonding method. The effects of different terminal atoms on the electronic structure and bonding characteristics of the α-Fe(100)/NbC(100) interface were analyzed. The bonding characteristics of the atomic interfaces I and II of the two interface models demonstrated covalent binding of different intensities. Interface I depends on the covalent-ionic bond formed by Fe and C atoms, while interface II relies on metal bonds formed by Fe and Nb atoms and weaker Fe-C bonds. Mulliken's analysis revealed that the bond population of Fe-Nb at interfaces I and II were negative, indicating an intense anti-bonding state between Fe and Nb atoms and a severe anti-bonding effect of Fe-Nb at interface II, resulting in its structural instability. Moreover, because of the covalent bonding (Fe-C) at interface I, the binding strength of the interface was higher with a stable interface.

Interfacial structure of WC-Fe metal-matrix composite (WC/Fe3W3C and Fe/Fe3W3C) stability, electronic and mechanical properties from first-principles calculations

First principles calculation of interfacial stability, electronic and mechanical properties of WC-304 cemented carbides

Thermodynamic analysis of the interface reaction and thermal stress of WCp/Fe composites

Interface microstructure and abrasive wear properties of WC-iron matrix composites with Ni, Mo, Fe added to the preforms

First-principles study on the interfacial electronic structure and analysis of the bonding properties of NbC/Fe composites

Investigation on the WC/Cu interfacial bonding properties: First-principles prediction and experimental verification

Interface alloying design to improve the stability and cohesion of W/HfC interface by first-principles study

First-principles simulations of metal-ceramic interface adhesion: Co/WC versus Co/TiC

Effect of alloying elements on interfacial properties and mechanical behavior of Mg/WC systems: A first-principles study

Effect of rare-earth elements on the interface of WC/α-Fe cemented carbide: A first-principles calculation

First-principles study on stability, adhesion and fracture properties of ZrO2/W interface in composite materials

Effect of WC mass fraction on the microstructure and frictional wear properties of WC/Fe matrix composites

Stability and fracture mechanism of α-Fe/V6C5 interface in high vanadium Fe-based alloys by first-principles calculations

Comparative research on the interfacial properties of Ni/diamond and Ni/graphene interface with Cr, B, and Si additions by first-principles calculation

Enhancing strength-ductility properties of immiscible W-Cu composite by creating low-energy phase interfaces

First principles application for mechanical properties of Ti-doped W particles enhanced U matrix composite

Density functional theory investigation on the stability, adhesion strength, tensile properties and fracture behavior of γ-Fe/Cu heterogeneous nucleation interface

The first-principles and ab initio molecular dynamics simulations revealing the interface energy of the NbC/α-Fe

Evaluation of structural and mechanical strength of symmetric tilt interface in W/Fe composite laminate using molecular dynamics

Strengthening Mechanisms and Research Progress in the W/Cu Interfaces

First-principles calculation on β-SiC(111)/α-WC(0001) interface