Abstract:The physical properties of metal-based structural materials, such as hardness, strength and toughness, are directly or indirectly affected by residual stress inside or on the surface of the given part. Repeated rapid heating and cooling during the additive manufacturing process causes thermal gradients and expansion and contraction in the material, which causes residual stress. Tensile residual stresses are known to exist on the surface of additive manufactured products and should be kept to a minimum as they affect the mechanical properties and lead to product deformation and product failure. Therefore, it is important to evaluate the residual stress after making the product and to control it under the desired conditions. There are limitations to using the destructive method commonly used for residual stress evaluation with additive manufacturing products, due to difficulties in repeated measurements, product size, and cost issues. Therefore, it is necessary to apply a non-destructive evaluation method and verify the validity of the method. In this study, A356.2 aluminum alloy powders were used for additive manufacturing using the powder bed fusion process, and the surface residual stress generated during the process was measured. X-ray diffraction (XRD) methods were used to observe the surface residual stress. After XRD measurement, analyses were performed using the Williamson-Hall plot, sin 2 ψ, and cosα methods. The residual stress measurement results of samples manufactured through the LPBF process and the characteristics and limitations of each method were discussed.

Stress Evaluation and Structural Analysis of Epoxy Resin by X-ray Measurement

X-Ray Computer Tomography on Residual Stress Measurement

THE-STATE-OF-THE-ART OF THE STUDY ON RESIDUAL STRESS MEASUREMENT BY X-RAY ANALYSIS

Method to Analyze and Evaluate the Depth Profile of the Three Dimensional Residual Stresses State with X-ray

An Analysis of Photopolymerization Kinetics and Stress Development in Multifunctional Acrylate Coatings

Simultaneous Measurement of Polymerization Kinetics and Stress Development in Radiation-Cured Coatings: A New Experimental Approach and Relationship between the Degree of Conversion and Stress

Effects of Stress on the Adhesive Behavior of Photoresist

Analysis of Stress Transfer in Two-Phase Polymer Systems Using Synchrotron Microfocus X-ray Diffraction

Interfacial stress concentration and the effect of residual microstress on tensile fracture in filled epoxy resins

X-ray Diffraction for the Determination of Residual Stress of Crystalline Material: An Overview

Stress analysis of polycrystalline thin films and surface regions by X-ray diffraction

A Study of the Residual Microstress at the Matrix Interface in Filled Epoxy Resins

Characterization of the flexural behavior of a reactive graphitic nanofibers reinforced epoxy using a non-linear damage model

Fine residual stress distribution measurement of steel materials by SOI pixel detector with synchrotron X-rays

X-Ray Stress Measurement for Rolled Magnesium Alloy AZ61 Made by Twin-Roll Casting

X-ray stress measurement with two-dimensional detector based on Fourier analysis

Strains and Stresses in Multilayered Materials Determined Using High-Energy X-ray Diffraction

Residual Stress Analysis of Additive Manufactured A356.2 Aluminum Alloys using X-Ray Diffraction Methods

Residual Stress of Individual Aluminum Grains from Three Dimensional X-Ray Diffraction

Estimation of residual stress relaxation in low alloy steel with different hardness during fatigue by in situ X-ray measurement

Testing and Representation of Strain Rate Sensitive Mechanical Properties of Epoxy Resin