Abstract:After the converter steelmaking process, a considerable number of ferroalloys are needed to remove dissolved oxygen from the molten steel, but it also forms a lot of oxide inclusions that cannot be completely removed. At the same time, it increases the carbon emissions in the steel production process. After years of research, our team have developed a series of clean deoxidation technologies, including carbon deoxidation, hydrogen deoxidation, and waste plastic deoxidation of molten steel to address the aforementioned issues. In this study, thermodynamic calculations and laboratory experiments were employed to verify that carbon and hydrogen can reduce the total oxygen content in the molten steel melt to below 5 × 10 −6 and 10 × 10 −6 , respectively. An analysis of the deoxidation mechanisms and effects of polyethylene and polypropylene was also conducted. In addition, the applications of carbon deoxidation technology in different steels with the hot-state experiment and industrial production were discussed carefully. The carbon deoxidation experimental results of different steels were as follows: (1) the oxygen content of bearing steel was effectively controlled at 6.3 × 10 −6 and the inclusion number density was lowered by 74.73% compared to aluminum deoxidized bearing steel; (2) the oxygen content in gear steel was reduced to 7.7 × 10 −6 and a 54.49% reduction of inclusion number density was achieved with almost no inclusions larger than 5 μm from the average level of industry gear steels; (3) a total oxygen content of M2 high-speed steel was as low as 3.7 × 10 −6 . In industrial production practice, carbon deoxidation technique was applied in the final deoxidation stage for non-aluminum deoxidized bearing steel, and it yielded excellent results that the oxygen content was reduced to below 8 × 10 −6 and the oxide inclusions in the steel mainly consist of silicates, along with small amounts of spinel and calcium aluminate.

Research status of inclusions in bearing steel and discussion on non-alloy deoxidation process

Thermodynamics of the Formation of Non-Metallic Inclusions during the Deoxidation of GCr15 Bearing Steel

Development and prospects of molten steel deoxidation in steelmaking process

Oxide Inclusions in Aluminum-deoxidized Ultra-low CarbonSteel

Effect of Silicon–Manganese Deoxidation on Oxygen Content and Inclusions in Molten Steel

Effect of Deoxidizing and Alloying Routes on the Evolution of Non-Metallic Inclusions in 55SiCr Spring Steel

Study on the thermodynamic stability and evolution of inclusions in Al–Ti deoxidized steel

Research progress in influence of non-metallic inclusion characteristics on fatigue properties of iron and steel materials

Current Status of Metallurgical Quality and Fatigue Performance of Rolling Bearing Steel and Development Direction of High-End Bearing Steel

Research on Inclusion Evolution during Re-Heating Process in Ti-Zr Deoxidized Low Carbon Steel

New steelmaking process based on clean deoxidation technology

Effect of Aluminum Alloying on the Hot Deformation Behavior of Nano-bainite Bearing Steel

Influence of Al addition on the grain boundary oxidation of Ultra High Strength Steels during hot coiling

Transient Behavior and Thermodynamics of Inclusions in Al-Ti-Deoxidized and Ca-Treated Steel

Study of the relationship among total oxygen, inclusions and fatigue properties of gear steel

A New Understanding of Deoxidation by Aluminum in Steels

Evolution mechanism of inclusions during refining and continuous casting process of 321H stainless steel

Formation and Removal Mechanism of Nonmetallic Inclusions in 42CrMo4 Steel during the Steelmaking Process

Inclusions modification by rare earth in steel and the resulting properties: A review

Effect of Al Content on the Agglomeration Behavior of Inclusions in High Al Steel

Evolution Mechanism of Inclusions in H13 Steel with Rare Earth Magnesium Alloy Addition