Abstract:Functional Materials Letters, Ahead of Print. BaTiO3/Nb:SrTiO3 thin film oxides have been deposited on SrTiO3 substrates using a pulsed laser deposition system. Different annealing methods were thereafter used to assess the ferroelectricity of the grown films. The residual polarization value, 2Pr, of 4.205 [math]C/cm2 and saturated residual polarization value, 2Pmax, of 15.484 [math]C/cm2 were obtained using in-situ annealing. After performing rapid thermal annealing (RTA) annealing, the residual polarization value rose to 4.676 [math]C/cm2 and the saturated residual polarization value rose to 18.723 [math]C/cm2. Furthermore, a comparison of results showed that the saturation test frequency of the in-situ annealing was 10 times higher than the saturation test frequency of the RTA. This could be explained by the fact that the secondary high-temperature annealing led to a decrease in the conductivity of the doped oxide and, thereby, a decrease in the effective electric field that was applied to both ends of the BTO (BaTiO3) film. Thus, a lower frequency was required to ensure a flip of all ferroelectric domains within the BTO film. By testing the fatigue frequency at 100 kHz, 10[math] stable cycles in both annealing methods and the results confirmed the good stability of the device performance. A linear fit analysis of the [math]–[math] curves showed under in-situ annealing the presence of both a bulk-limited current mechanism that was dominated by the space charge limited current (SCLC) and Pool–Frenkel (PF) mechanisms, and an interface-limited current that was dominated by the Fowler–Nordheim (FN) mechanism in the structure. After RTA annealing, the conducting mechanism is ohmic contact at low electric field and the SCLC mechanism at high field strength. The results show that after RTA annealing, the quality and ferroelectric properties of the films are significantly improved compared to those under in-situ annealing. These results showed that the BTO/NSTO/STO (BaTiO3/Nb:SrTiO3/SrTiO3) structure had a standard test frequency as well as reliable stability. The BTO/NSTO/STO structure showed, therefore, promising applications in future nonvolatile information memory devices.

Anneal temperature dependence of resistive switching and photoelectric properties of Bismuth ferrite thin film prepared via sol–gel method

The effect of in situ annealing oxygen pressure on the ferroelectric resistive switching characteristic

Spatially-Resolved Study of the Electronic Transport and Resistive Switching in Polycrystalline Bismuth Ferrite

Reliable ferroelectricity in sol–gel‐derived BiFeO3 thin films below 200 nm

Anomalous Conductivity Behavior Induced by in Situ Metastable Amorphous Phase in BaTiO3/Ni0.5Zn0.5Fe2O4 Ceramic Composite

Multiferroic properties and resistive switching behaviors of Ni0.5Zn0.5Fe2O4 thin films

Effect of annealing process on dielectric and multiferroic properties of Sol-Gel derived bismuth chromate thin films

Effects of Annealing Temperature on the Structures, Ferroelectric and Magnetic Properties of Aurivillius Bi5ti3feo15 Polycrystalline Films

Modified ferroelectric and photovoltaic properties of BiFe 0.91 Zr 0.09 O 3 thin films via altered annealing atmospheres

Temperature-Dependent Electrical Characterization of Multiferroic BiFeO3 Thin Films

Resistive Switching Effect of Multiferroic Complex Oxide Solid Solution Thin Films

Mechanism of Ferroelectric Resistive Switching in Bi0.9la0.1feo3 Thin Films

Ferroelectric properties and current mechanisms of BaTiO[math]/Nb:SrTiO[math] thin films

Temperature Dependences of Ferroelectricity and Resistive Switching Behavior of Epitaxial Bifeo3 Thin Films

Effect of annealing temperature on the properties of 0.5Bi4Ti3O12-0.5BiFe0.98Mn0.02O3 thin films

Structure evolution of the interfacial layer of BaTiO3 thin films during annealing process and related good resistive switching behaviors

Electrical Conduction Mechanisms and Effect of Atmosphere Annealing on the Electrical Properties of BiFeO3-BaTiO3 Ceramics

Structure and Characteristics of the BiFeO3 Fabricated by the Sol-Gel Technique

Study of structural, optical and enhanced multiferroic properties of Ni doped BFO thin films synthesized by sol-gel method

Tuning Phase Fractions and Leakage Properties of Chemical Solution Deposition-Derived Mixed-Phase BiFeO 3 Thin Films

Effects of solvents and Al doping on structure and physical properties of BiFeO3 thin films