Abstract:Functional Materials Letters, Ahead of Print. BaTiO3/Nb:SrTiO3 thin film oxides have been deposited on SrTiO3 substrates using a pulsed laser deposition system. Different annealing methods were thereafter used to assess the ferroelectricity of the grown films. The residual polarization value, 2Pr, of 4.205 [math]C/cm2 and saturated residual polarization value, 2Pmax, of 15.484 [math]C/cm2 were obtained using in-situ annealing. After performing rapid thermal annealing (RTA) annealing, the residual polarization value rose to 4.676 [math]C/cm2 and the saturated residual polarization value rose to 18.723 [math]C/cm2. Furthermore, a comparison of results showed that the saturation test frequency of the in-situ annealing was 10 times higher than the saturation test frequency of the RTA. This could be explained by the fact that the secondary high-temperature annealing led to a decrease in the conductivity of the doped oxide and, thereby, a decrease in the effective electric field that was applied to both ends of the BTO (BaTiO3) film. Thus, a lower frequency was required to ensure a flip of all ferroelectric domains within the BTO film. By testing the fatigue frequency at 100 kHz, 10[math] stable cycles in both annealing methods and the results confirmed the good stability of the device performance. A linear fit analysis of the [math]–[math] curves showed under in-situ annealing the presence of both a bulk-limited current mechanism that was dominated by the space charge limited current (SCLC) and Pool–Frenkel (PF) mechanisms, and an interface-limited current that was dominated by the Fowler–Nordheim (FN) mechanism in the structure. After RTA annealing, the conducting mechanism is ohmic contact at low electric field and the SCLC mechanism at high field strength. The results show that after RTA annealing, the quality and ferroelectric properties of the films are significantly improved compared to those under in-situ annealing. These results showed that the BTO/NSTO/STO (BaTiO3/Nb:SrTiO3/SrTiO3) structure had a standard test frequency as well as reliable stability. The BTO/NSTO/STO structure showed, therefore, promising applications in future nonvolatile information memory devices.

The effect of in situ annealing oxygen pressure on the ferroelectric resistive switching characteristic

Oxygen-vacancy-induced Reversible Control of Ferroelectric Polarization in Ba4Eu2Fe2Nb8O30 Ceramics

Anneal temperature dependence of resistive switching and photoelectric properties of Bismuth ferrite thin film prepared via sol–gel method

Impact of annealing atmosphere on the multiferroic and dielectric properties of BiFeO 3 /Bi 3.25 La 0.75 Ti 3 O 12 thin films

Impact of annealing atmosphere on the multiferroic and dielectric properties of BiFeO<sub>3</sub>/Bi<sub>3.25</sub>La<sub>0.75</sub>Ti<sub>3</sub>O<sub>12</sub> thin films

Structure evolution of the interfacial layer of BaTiO3 thin films during annealing process and related good resistive switching behaviors

Resistive Switching in BiFeO_3 -Based Heterostructures Due to Ferroelectric Modulation on Interface Schottky Barriers

Electrical Conduction Mechanisms and Effect of Atmosphere Annealing on the Electrical Properties of BiFeO3-BaTiO3 Ceramics

Reliable ferroelectricity in sol–gel‐derived BiFeO3 thin films below 200 nm

Effects of Chemical Fluctuations on Microstructures and Properties of Multiferroic Bifeo3 Thin Films

Ferroelectric properties and current mechanisms of BaTiO[math]/Nb:SrTiO[math] thin films

Influences of oxygen pressure on optical properties and interband electronic transitions in multiferroic bismuth ferrite nanocrystalline films grown by pulsed laser deposition.

Effects of anneal atmosphere on the structural and ferroelectric properties of SrBi2Ta2O9 thin films

Effect of Annealing on Ferroelectric Properties of Nanometre BaTiO 3 Ceramics Prepared by High Pressure Sintering Method

Effect of polarization on tunnelling electroresistance in ferroelectric tunnel junctions

Structure evolution and energy band modulation in Ba-doped BiFeO3 thin films

Multiferroic properties and resistive switching behaviors of Ni0.5Zn0.5Fe2O4 thin films

Electric-field-induced non-ergodic relaxor to ferroelectric transition in BiFeO3-xSrTiO3 ceramics

Electric-field-induced non-ergodic relaxor to ferroelectric transition in BiFeO3- x SrTiO3 ceramics

Synthesis And Ferroelectric Properties Of Bifeo3 Thin Films Grown By Sputtering

SYSTEMATIC EXPLORATION OF THE EFFECTS OF CR-DOPING ON MICROSTRUCTURE, INSULATING, AND FERROELECTRIC PROPERTIES OF BiFeO3 THIN FILM