Abstract:Although heavy ion irradiation is a good tool to simulate neutron irradiation-induced damages in light water reactor, it produces inhomogeneous defect distribution. Such difference in defect distribution brings difficulty in comparing the microstructure evolution and mechanical degradation between neutron and heavy ion irradiation, and thus needs to be understood. Stainless steel is the typical structural material used in reactor core, and could be taken as an example to study the inhomogeneous defect depth distribution in heavy ion irradiation and its influence on the tested irradiation hardening by nano-indentation. In this work, solution annealed stainless steel model alloys are irradiated by 3MeV Fe2+ ions at 400°C to 3dpa to produce Frank loops that are mainly interstitial in nature. The silicon content of the model alloys is also tuned to change point defect diffusion, so that the loop depth distribution influenced by diffusion along the irradiation beam direction could be discussed. Results show that in low Si (0% Si) and base Si (0.42% Si) samples the depth distribution of Frank loop density quite well matches the dpa profile calculated by the SRIM code, but in high Si sample (0.95% Si), the loop number density in the near-surface region is very low. One possible explanation could be Si’s role in enhancing the effective vacancy diffusivity, promoting recombination and thus suppressing interstitial Frank loops, especially in the near-surface region, where vacancies concentrate. By considering the loop depth distribution, the tested irradiation hardening is successfully explained by the Orowan model. A hardening coefficient of around 0.30 is obtained for all the three samples. This attempt in interpreting hardening results may make it easier to compare the mechanical degradation between different irradiation experiments.

Effects of excess electrons/holes on fracture toughness of single-crystal Si

Atomistic Investigations of Single-Crystal Silicon with Pre-Existing Defects

The Tensile Effect on Crack Formation in Single Crystal Silicon Irradiated by Intense Pulsed Ion Beam

Defects Evolution in N-Type 4H-Sic Induced by Electron Irradiation and Annealing

Damage Effects in 6H-Sic Single Crystals by Si&H Dual Ion Irradiation: A Combined Raman and XRD Study

Enhanced strength and ductility of superhard boron carbide through injecting electrons

Damage Production in Silicon Carbide by Dual Ion Beams Irradiation

Structure and fracture behavior of ion-beam-modified SiC-Al2O3-ZrO2 ceramic composites

Mechanical Properties and Structure Evolution of Single-Crystalline Silicon Irradiated by 1 MeV Au+ and Cu+ Ions

Optical Properties and Laser Damage Performance of Sio2 Irradiated by High-Power Pulsed Electron Beam

Fracture analysis of surface exfoliation on single crystal silicon irradiated by intense pulsed ion beam

General Model for Defect Dynamics in Ionizing-Irradiated SiO<sub>2</sub>-Si Structures

Study of irradiation damage in silicon at different scales

Ti3SiC2 irradiation damage at electron beam energy levels of 120 keV and 200 keV

Investigation of the damage behavior in SiC without any additives irradiated with Si ions by GIXRD, Raman and TEM

Effect of Ion Irradiation on Nanoindentation Fracture and Deformation in Silicon Carbide

General Model for Defect Dynamics in Ionizing‐Irradiated SiO 2 ‐Si Structures

Damage Effects of Au&He Dual Ion Irradiated Silicon Carbide

Depth Distribution of Frank Loop Defects Formed in Ion-Irradiated Stainless Steel and Its Dependence on Si Addition

Impact of electron irradiation on semi-insulating and conductive β-Ga 2 O 3 single crystals

Direct simulation of ion beam induced stressing and amorphization of silicon