Abstract:This theoretical modeling and simulation paper presents designs and projected performances of two non-volatile, broadband, on-chip 2-by-2 electro-optical switches based upon the germanium-on-insulator (GeOI) photonic-electronic platform operating at the 2.5 $\mu$m mid-infrared wavelength. These compact devices facilitate large-scale integration on a monolithic wafer where all components are made of group-IV semiconductors. The switches are the two-waveguide directional coupler (DC) and the Mach-Zehnder interferometer (MZI). A thin-film graphene Joule-effect micro-heater is assumed on the planarized GeOI device to change the phase (reversably) of DC-slot-embedded Sb$_2$Se$_3$ phase-change material (PCM) from crystalline to amorphous. The MZI has this PCM within its slotted-arm waveguides. Simulations show high-performance bistable or multi-stable cross-bar switching in both devices. The 2-by-2 DC has an active coupling length of 17 $\mu$m, 130 nm gap, and a footprint of 5 $\mu$m -by- 31 $\mu$m. The device bandwidth is 30 nm over a wavelength range where cross and bar insertion losses IL are less than 0.3 dB, and where optical crosstalk is less than -15 dB. Results for the 2-by-2 MZI show crossbar switching attained with a 7.8 $\mu$m-length Sb$_2$Se$_3$ slot and a 5 $\mu$m -by- 51 $\mu$m switch footprint. Stable, multi-level switching in both devices is attained via partial amorphization. Thermal modeling shows that careful control of the voltage-pulse amplitude V applied to graphene (rectangular pulse duration of 500 ns) can give 32 levels, for example, using V in the range from 6.18 to 7.75 Volts.

Reconfigurable InP waveguide components using the Sb2S3 phase change material

Reconfigurable Hybrid Silicon Waveguide Bragg Filter Using Ultralow-Loss Phase-Change Material.

Non‐Volatile Optical Switch Element Enabled by Low‐Loss Phase Change Material

Mid-infrared Nonlinear Silicon Hybrid Waveguide with High Figure of Merit

Nonvolatile Electrically Reconfigurable Silicon Photonics Enabled by Back-End-of-line Integration of Phase Change Materials

Non‐Volatile Reconfigurable Integrated Photonics Enabled by Broadband Low‐Loss Phase Change Material

Nonvolatile Multilevel Switching of Silicon Photonic Devices with In2O3/GST Segmented Structures

Improved digital optical switching using carrier injection induced reconfigurable waveguides

Nonvolatile Multilevel Switching of Silicon Photonic Devices with In<sub>2</sub>O<sub>3</sub>/GST Segmented Structures

Reversible Thermally Driven Phase Change of Layered In2Se3 for Integrated Photonics.

Reconfigurable inverse designed phase-change photonics

Magnetron-sputtered and Thermal-Evaporated Low-Loss Sb-Se Phase-Change Films in Non-Volatile Integrated Photonics

Inverse design of compact nonvolatile reconfigurable silicon photonic devices with phase-change materials

Germanium-On-Silicon Nitride Waveguides for Mid-Infrared Integrated Photonics

On-Chip Reconfigurable and Ultracompact Silicon Waveguide Mode Converters Based on Nonvolatile Optical Phase Change Materials

Compact Non-Volatile Multilevel Sb$_2$Se$_3$ Electro-Optical Switching in the Mid-Infrared Group-IV-Photonics Platform

Silicon-on-Insulator Waveguide Devices for Broadband Mid-Infrared Photonics

Port reconfigurable phase-change resonator

Multiphysics simulations of a cylindrical waveguide optical switch using phase change materials on silicon

A Semiconductor Under Insulator Technology in Indium Phosphide

Research on reconfigurable waveguide devices based on liquid crystal on silicon