Abstract:Three-dimensional concrete printing (3DCP) technology with solid wastes has significant potential for sustainable construction. However, the hardened mechanical properties of components manufactured using 3DCP technology are affected by weak interlayer interfaces, limiting the widespread application of 3DCP technology. To address the inherent limitations of 3DCP technology, conventional improvement strategies, such as external reinforcement and the optimization of material properties, lead to increased production costs, complex fabrication, and decreased automation. This study proposes an innovative spatial path optimization method to enhance the mechanical performance of 3D-printed, cement-based components. The novel S-path design introduces additional printed layers in the weak interlayer regions of the printed samples. This design improves the spatial distribution of fiber-reinforced filaments in continuous weak zones, thus enhancing the functional efficiency of fibers. This approach improves the mechanical performance of the printed samples, achieving compressive strengths close to those of cast samples and only a 20% reduction in average flexural strength. Compared to using a conventional printing path, the average compressive strength and flexural strength are improved by 30% and 55%, respectively, when the S-path layout is employed in 3DCP. Additionally, this method significantly reduces the anisotropy in compressive and flexural strengths to 26% and 28% of samples using conventional printing paths, respectively. Therefore, the proposed method can improve the mechanical properties and stability of the material, reducing the safety risks of printed structures.

U-type steel wire mesh for the flexural performance enhancement of 3D printed concrete: A novel reinforcing approach

Investigation of steel wire mesh reinforcement method for 3D concrete printing

In-process reinforcing method: dual 3D printing procedure for ultra-high performance concrete reinforced cementitious composites

3D Printed Concrete Walls Reinforced with Flexible FRP Textile: Automatic Construction, Digital Rebuilding, and Seismic Performance

Experimental and numerical study on the flexural behavior of 3D-printed composite beams with U-shaped ECC formwork

3D-printing ultra-high performance fiber-reinforced concrete under triaxial confining loads

Development of 3D-printable ultra-high performance fiber-reinforced concrete for digital construction

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Behavior of 3D-printed HPC plates with FRP grid reinforcement under bending

Flexural performance of 3D-printed composite beams with ECC and recycled fine aggregate concrete: Experimental and numerical analysis

Interlayer reinforcement of 3D printed concrete by the in-process deposition of U-nails

3D printing of FRP grid and bar reinforcement for reinforced concrete plates: Development and effectiveness

Mechanical behavior of FRP sheets reinforced 3D elements printed with cementitious materials

Experimental study and design approach on 3D printed concrete walls under eccentric axial compression

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Mechanical properties of a 3D-printed SFRC beam with steel fiber distribution adaptive to tensile stress

Shear Performance of 3D Printed Concrete Reinforced with Flexible or Rigid Materials Based on Direct Shear Test

Mechanical Properties of Spray-Based 3D Printed Micro-cable Reinforced Concrete

Flexural properties of three-dimensional printed continuous wire polymer composites

Rheological characterization of ultra-high performance concrete for 3D printing

An integrated topology optimization method including manufacturing constraints for 3D printed fiber-reinforced concrete structures