Abstract:Understanding the advantages of combining traditional construction methods and 3D concrete printing is the gateway to the general structural applicability of three-dimensional concrete printing (3DCP) technology. To further this objective, in this study, 3D-printed concrete is used as permanent formwork for the manufacture of reinforced concrete beams. Different treatment methods for the interfaces between the printed formwork and the cast core concrete, including embedding of shear connectors, entraining of micro-cables, and inclusion of ribs in the 3D printing of the formwork, are explored to improve the integral mechanical capacities of so-called 3D-printed and cast-in-place composite beams. Specifically, flexural behaviors are studied experimentally through observation of damage and failure processes via visualization with the digital image correlation (DIC) method. The mesoscale architecture at the interface between 3D-printed permanent formwork and cast-in-place concrete is investigated through computed tomography (CT) scanning to infer the cooperative bonding mechanisms of different bonding treatment methods. The stress-transfer mechanism is thus elucidated. The applicability of 3D-printed concrete as permanent formwork is validated in view of a 14.3% increase in the bending capacity from a composite beam with bottom ribs compared to that of a completely cast counterpart. From the experiments, incorporation of shear connectors contributes most to the bonding performance of the formwork–concrete interfaces. Meanwhile, interfacial bonding can be enhanced by increasing the roughness of the 3D-printed formwork, interlocking of the formwork with the inner aggregated concrete, or improving the consistency of the elastic and shear moduli of the formwork and cast concrete. In particular, the appropriate thickness of both the formwork and the aggregated concrete as a cover to yield the optimal integrated bending capacity of composite beams is derived from the current study.

Mechanical behavior of FRP sheets reinforced 3D elements printed with cementitious materials

Effect of Reinforcement Configurations on the Flexural Behaviors of 3D Printed Fiber Reinforced Cementitious Composite (FRCC) Beams

Mechanical Properties of 3D Printed ECC Beams Reinforced with FRP Mesh

3D printing of FRP grid and bar reinforcement for reinforced concrete plates: Development and effectiveness

Behavior of 3D-printed HPC plates with FRP grid reinforcement under bending

Novel 3D FRP System Used for More Effectively and Readily Strengthening of Precast Concrete Elements

Performance Evaluation of Reinforced Concrete Beam with 3D-Printed Permanent Formwork

3D FRP Reinforcement Systems for Concrete Beams: Innovation towards High Performance Concrete Structures

Compressive Behavior of FRP-confined 3D Printed Ultra-High Performance Concrete Cylinders

Experimental Investigation on Flexural Capacity of Reinforced Concrete Beams Strengthened with 3D-Fiberglass, CFRP and GFRP

3D-printing ultra-high performance fiber-reinforced concrete under triaxial confining loads

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

Flexural performance of 3D-printed composite beams with ECC and recycled fine aggregate concrete: Experimental and numerical analysis

Tensile and Flexural Properties of 3D-Printed Jackets-Reinforced Mortar

The ways and mechanisms of using CFRP materials to strengthen the flexural performance of reinforced concrete beams

Study on the Fracture Behavior and Anisotropy of 3D-Printing PVA Fiber-Reinforced Concrete

Mechanical Behavior of Concrete Columns Confined with CFRP Grid-Reinforced Engineered Cementitious Composites

Design and Optimization of 3D-Printed Variable Cross-Section I-Beams Reinforced with Continuous and Short Fibers

Mechanical Anisotropy of Ultra-High Performance Fibre-Reinforced Concrete for 3D Printing

Anisotropic Behavior in Bending of 3D Printed Concrete Reinforced with Fibers

Experimental and numerical study on the flexural behavior of 3D-printed composite beams with U-shaped ECC formwork