Abstract:Construction three-dimensional (3D) printing is an emerging technology within the area of Additive Construction and has the potential of revolutionizing the construction industry and the structural engineering discipline through construction automation. One of the major challenges in construction 3D printing is the lack of understanding of the response of 3D printed elements as well as the lack of design methodologies for such elements. This study proposes a 3D printed concrete (3DPC) wall design, termed RC-framed 3DPC wall, for applications in the seismic force resisting system of low-rise 3DPC buildings. The proposed 3DPC wall is reinforced by an internal reinforced concrete frame that strengthens the 3DPC wall similarly to boundary elements in masonry walls. The proposed 3DPC wall further includes bed-joint reinforcement that provides strength against shear demands and provides stability during printing. This study further discusses connection strategies of the proposed 3DPC wall to roof slabs and the foundation, and, following a limit states approach, formulates strength capacity equations for different in-plane failure mechanisms. In lack of experimental data, the strength equations are validated through finite element analyses as well as through experimental data on concrete block masonry (CBM) walls, with which 3DPC walls bear similarities in terms of the construction approach and are expected to share similar response mechanisms. Comparisons with experimental data were conducted for 16 partially grouted (PG) CBM walls and for 10 confined CBM walls. Comparisons with finite element analysis predictions were conducted for 96 3DPC walls, which varied in terms of bed-joint reinforcement, concrete compressive strength , height-to-length ratio, layer width, and cross-section infill pattern. These comparisons focused on predictions of strength and failure mechanisms. It was observed that the proposed strength design equations could predict the mechanical strength and failure mechanism of 3DPC walls with reasonable accuracy, thus, paving the way to 3DPC building design.

Experimental study and design approach on 3D printed concrete walls under eccentric axial compression

Experimental study on large-scale 3D printed concrete walls under axial compression

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Analysis and design of 3D printed reinforced concrete walls under in-plane quasi-static loading

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Seismic Performance of Reinforced Concrete Squat Walls with Embedded Cold-Formed and Thin Walled Steel Truss

Bonding performance of 3D printing concrete with self-locking interfaces exposed to compression–shear and compression–splitting stresses

Experimental Study on Axial Compressive Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Experimental Study on Lateral Resistance Behavior of Small Concrete Hollow Block Wall with Different Constructional Measures

Experimental and numerical study on the flexural behavior of 3D-printed composite beams with U-shaped ECC formwork

Stability Design of Multi-Celled Corrugated-Plate CFST Walls under Combined Axial and In-Plane Bending Loads

3D-printing ultra-high performance fiber-reinforced concrete under triaxial confining loads

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Study on axial compression bearing capacity of in-sulated sandwich concrete wall with embedded columns

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach

Anisotropic mechanical properties of extrusion-based 3D printed layered concrete

3D Printed Concrete Walls Reinforced with Flexible FRP Textile: Automatic Construction, Digital Rebuilding, and Seismic Performance

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

3D printed concrete with recycled sand: Pore structures and triaxial compression properties

Behavior of Axially Compressed Concrete-Reinforced Sandwich Wallboard