Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Mechanical Properties of Spray-Based 3D Printed Micro-cable Reinforced Concrete

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Expansive cementitious materials to improve micro-cable reinforcement bond in 3D concrete printing

Experimental Exploration of Metal Cable as Reinforcement in 3D Printed Concrete

Investigation of steel wire mesh reinforcement method for 3D concrete printing

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Shrinkage and mechanical properties optimization of spray-based 3D printed concrete by PVA fiber

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Mechanical behavior of FRP sheets reinforced 3D elements printed with cementitious materials

Anisotropic mechanical properties of extrusion-based 3D printed layered concrete

Performance of 3D-Printed Beams and Slabs Using Self-Sensing Cementitious Composites and DIC Method

The Influence of Three-Dimensionally Printed Polymer Materials as Trusses and Shell Structures on the Mechanical Properties and Load-Bearing Capacity of Reinforced Concrete

Modification effect of nanosilica and polypropylene fiber for extrusion-based 3D printing concrete: Printability and mechanical anisotropy

PVA Fibre Reinforced High-Strength Cementitious Composite for 3D Printing: Mechanical Properties and Durability

Interlayer reinforcement of 3D printed concrete by the in-process deposition of U-nails

Shear Performance of 3D Printed Concrete Reinforced with Flexible or Rigid Materials Based on Direct Shear Test

Behavior of 3D-printed HPC plates with FRP grid reinforcement under bending

3D printing of FRP grid and bar reinforcement for reinforced concrete plates: Development and effectiveness

Interfacial bonding properties of 3D printed permanent formwork with the post-casted concrete

Mechanical Properties of Structures 3D Printed with Cementitious Powders

Mechanical and macrostructural properties of 3D printed concrete dosed with steel fibers under different loading direction