Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Shrinkage and mechanical properties optimization of spray-based 3D printed concrete by PVA fiber

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Shrinkage and Cracking Performance of PP/PVA Fiber-Reinforced 3D-Printed Mortar

Pore structure, internal relative humidity, and fiber orientation of 3D printed concrete with polypropylene fiber and their relation with shrinkage

PVA Fibre Reinforced High-Strength Cementitious Composite for 3D Printing: Mechanical Properties and Durability

Shrinkage and Cracking Properties of Cellulose Fiber–Concrete Composites for 3D Printing by Leveraging Internal Curing

Study on anisotropy of 3D printing PVA fiber reinforced concrete using destructive and non-destructive testing methods

Modification effect of nanosilica and polypropylene fiber for extrusion-based 3D printing concrete: Printability and mechanical anisotropy

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Rheology and shrinkage of concrete using polypropylene fiber for 3D concrete printing

State-of-the-art of Mechanical Properties of 3D Printed Concrete

Research on the Preparation and Mechanical Properties of Solidified 3D Printed Concrete Materials

Methods for measuring plastic shrinkage and related cracking of 3D-printed concrete

Plastic shrinkage cracking in 3D printed concrete

Rheological behaviors and structure build-up of 3D printed polypropylene and polyvinyl alcohol fiber-reinforced calcium sulphoaluminate cement composites

Three-Dimensional Printable Concrete by an Ultra-Thin Nozzle and Fully Sealed Extrusion

Extrusion-based 3D Printing Concrete with Coarse Aggregate: Printability and Direction-Dependent Mechanical Performance

Comparison of Printability and Mechanical Properties of Rigid and Flexible Fiber-Reinforced 3D Printed Cement-Based Materials

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

Optimization of 3D printing concrete with coarse aggregate via proper mix design and printing process

Mechanical Properties of Spray-Based 3D Printed Micro-cable Reinforced Concrete