Abstract:Flexible rolling is important for increasing rolling production capacity. Since the wear rolls withdrawn and new rolls launched into the rolling process causing thermal deformation parameters variation, such as deformation temperature, strain rate, and strain. This paper studies the coupling behavior of static recrystallization (SRX), metadynamic recrystallization (MDRX), and thermal deformation parameters based on the double-pass thermal simulation experiments, analyzes the flow stress curves and reveals the variation law of recrystallization with thermal deformation parameters. The result shows that the second-pass flow stress of SRX is significantly dependent on the inter-pass time, deformation temperature and strain rate, Compared to MDRX, SRX requires time to nucleus of conception and is more influenced by initial strain. Considering the recovery effect and the multi-pass static softening solution algorithm of materials, the kinetic models of SRX and MDRX are established, and the predicted values of the models are in good agreement with the experimental values. The EBSD microstructure characterization technique is used to characterize the morphology of SRX and MDRX. The result shows that increasing inter-pass time, deformation temperature and strain rate can promote the SRX and MDRX process and improve static softening effect. Under the condition of constant deformation temperature and strain rate, increasing the initial strain can increase the SRX volume fraction. However, deformation temperature and strain rate have a more significant effect on the static softening than the initial strain. This paper provides a theoretical basis for designing and optimizing recrystallization behavior of flexible rolling gaps.

Effect of Softening on the Mechanical Properties and Formability of Ribbon from Alloy 3104

Effect of Alloying Elements and Processing Parameters on Microstructure and Properties of 1XXX Aluminium Alloys

Study of the deep drawing behavior and crystallographic texture of AA 3104-H19 aluminum alloy sheets

The Effects of Cold Rolling and Stabilization Treatment on the Improvement of Microstructure, Mechanical Properties, and Corrosion Behavior of AA5083 Sheet

Effect of plastic anisotropy on ironing formability of 3104 aluminum alloy hard sheets

Effects of heat treatment on a novel continuous casting direct rolling 6056 aluminum alloy: cold rolling characteristics and tensile fracture properties

Influence of different rolling processes on the microstructures and mechanical properties of 6016 aluminum alloy

Effects Of Rolling Process On Microstructure And Mechanical Property Of 7050 Aluminum Alloy

Deformation and Recrystallization Textures in Straight-Rolled and Pseudo Cross-Rolled AA 3105 Aluminum Alloy

Effect of annealing process on microstructure and mechanical properties of precipitated phase of A1235 aluminum alloy

Microstructure Evolution and Mechanical Properties of Rheo-Processed ADC12 Alloy

Effect of Final Rolling Temperature on Microstructures and Mechanical Properties of AZ31 Alloy Sheets Prepared by Equal Channel Angular Rolling and Continuous Bending

Static softening behavior of 316L stainless steel under flexible rolling process

Effects of Rolling Temperature on Hot Rolling Behaviors and Mechanical Properties of ABOw/6061Al Composites

Effect of Tempforming on Strength and Toughness of Medium-Carbon Low-Alloy Steel

Effect of Rolling on the Microstructure and Mechanical Properties of (fecrni)94ti3al3 Medium Entropy Alloy Fabricated Via Selective Laser Melting

Influence of alloy chemistry on the deformation behaviour and anisotropic properties of aluminium ultra-fine-grained thin sheets

Effect of radial shear rolling on grain refinement and mechanical properties of the Al–Mg–Sc alloy

Microstructural Evolution and Mechanical Properties of Pure Aluminum upon Multi-Pass Caliber Rolling

Effect of Radial Shear Rolling on the Structure and Mechanical Properties of a New-Generation High-Strength Aluminum Alloy Based on the Al – Zn – Mg – Ni – Fe System

Microstructural change of 3104 aluminum alloy cold rolled sheets under paint baking temperature and role of solute atoms in paint baking softening behavior