Abstract:To use methanol as a mono-fuel in large bore marine engines, a distributed jets ignition combustion mode was applied on a 320 mm-bored engine, in which pre-chamber initiated jets were employed to ignite the in-cylinder lean mixtures and to enhance the flame propagation. A preliminary numerical study was carried out to investigate the effects of in-cylinder excess air ratio and ignition timing on combustion characteristics and performances of the engine. Conditions with excess air ratios ranged from 2.0 to 2.8 and ignition timings ranged from −8°CA ATDC to the top dead center were calculated. The numerical results show that, under the distributed jets ignition combustion mode, the in-cylinder lean methanol-air mixtures could be reliably ignited and the heat release rates showed a firstly slow and then rapid trend, resulting in high thermal efficiencies and low NO x emissions, which could meet for the IMO Tier III emission regulations without aftertreatment. Moreover, with the increase of the in-cylinder excess air ratio and the delaying of the ignition timing, the in-cylinder pressure, the peak pressure rising rate, the ringing intensity and the NO x emissions were continuously decreased. As the in-cylinder mixture becoming leaner, the combustion efficiency firstly kept constant and then rapidly dropped when the excess air ratio increased to 2.4, resulting in a peak value of the indicated thermal efficiency (49.2%) at this excess air ratio. According to the numerical results, a combustion control strategy was proposed: when the brake mean effective pressure was below 1.8 MPa, the in-cylinder excess air ratio was controlled at 2.4 and coupled with an earlier ignition timing to obtain high thermal efficiency, and when the brake mean effective pressure was higher than 1.8 MPa, the in-cylinder excess air ratio was controlled at 2.1 and coupled with a later ignition timing, thereby to achieve high power density.

Effects of Methanol Steam Reforming for Hydrogen-Rich Products on the Performance Enhancement of a Medium-Speed Marine Engine

Effects of hydrogen-rich products from methanol steam reforming on the performance enhancement of a medium-speed marine engine

Engine Performance and Emissions of A Compression Ignition Engine Operating on the Diesel-Methanol Blends

Optimization design and performance analysis of methanol reforming reactor for exhaust waste heat recovery of marine engine

Combustion and Emission Characteristics of a DI Diesel Engine Fueled by Diesel-Methanol Blends

Design and performance optimization of diesel engine waste heat recovery methanol reforming hydrogen generation system

Development of Highly Efficient Methanol Steam Reforming System for Hydrogen Production and Supply for a Low Temperature Proton Exchange Membrane Fuel Cell

Multi-objective optimization of the performance for a marine methanol-diesel dual-fuel engine

Performance and emissions of a high-speed marine dual-fuel engine operating with methanol-water blends as a fuel

Study on Combustion Characteristics of a DI Diesel Engine Operating on Diesel/Methanol Blends

Numerical Study of the Effect of Direct-Injection Timing of Methanol and Excess Air Ratio on the Combustion Characteristics of a Marine Diesel-Methanol Dual-Fuel Engine

Development of Multilevel Amplified Methanol Steam Reforming Microreactor with High Hydrogen Production Rate

Effects of fuel reforming on large-bore low-speed two-stroke dual fuel marine engine combined with EGR and injection strategy

A preliminary numerical study on the use of methanol as a Mono-Fuel for a large bore marine engine

Design, optimization and application of reformer in a marine natural gas engine: A numerical and experimental study

A novel thermally autonomous methanol steam reforming microreactor using SiC honeycomb ceramic as catalyst support for hydrogen production

Effects of Methanol Application on Carbon Emissions and Pollutant Emissions Using a Passenger Vehicle

A Micro-Reactor with Micro-Pin-fin Arrays for Hydrogen Production Via Methanol Steam Reforming

Performance optimization of a diesel engine fueled with hydrogen/biodiesel with water addition based on the response surface methodology

Experimental Investigation of Diluents Components on Performance and Emissions of a High Compression Ratio Methanol SI Engine