Abstract:Amine-grafted adsorbents are promising CO 2 adsorbents; however, the excessive addition of an amino silane coupling agent during their synthesis increases their production cost. Thus, using low amounts of silane, we synthesized 3-aminopropyltrimethoxysilane (APTMS)-grafted SBA-15 mesoporous silica and evaluated its CO 2 adsorption performance. APTMS-grafted SBA-15 samples were prepared using either impregnation or heating–filtration method (grafting). The obtained samples were characterized by X-ray diffraction spectroscopy, transmission electron microscopy, N 2 adsorption/desorption, scanning electron microscopy, magic-angle spinning nuclear magnetic resonance, and elemental analysis. The results revealed that the micropores of SBA-15 were preferentially blocked, and APTMS increasingly occupied the mesopores with increasing amine loading. The CO 2 -adsorption performance of the adsorbents was measured by thermogravimetric analysis under dry conditions. Both synthesis methods achieved high amine immobilization efficiency (78.3–92.2%), as estimated from the amount of silane coupling agents used in the synthesis and that immobilized on the support. The adsorbents prepared by the two methods adsorbed similar amounts of CO 2 of approximately 0.5 mmol g − 1 in 400 ppm CO 2 and ~ 1.0 mmol g − 1 in 5 vol% CO 2 . The adsorption amounts attained in this study are comparable to those of previously reported silane-coupling-agent-modified adsorbents that were prepared with more silane. In contrast, the adsorption rate of the samples was affected by the synthesis method, even with similar amine loadings. Nonetheless, the results revealed that even with a low amount of the silane coupling agent, high-performance amine-grafted CO 2 adsorbents could be synthesized.

Sillica Gel-Amine from Geothermal Sludge

Preparation and Co2 Sorption/Desorption of N-(3-Aminopropyl) Aminoethyl Tributylphosphonium Amino Acid Salt Ionic Liquids Supported into Porous Silica Particles

Synthesis of Silica Xerogel from Geothermal Sludge by Ultrasonic Assisted Alkali Extraction-Acid Precipitation

Preparation of amine functionalized silica by the one-step in spray drying system

Silica Gel Supported Solid Amine Sorbents for CO2 Capture

Aminosilanes grafted to basic alumina as CO2 adsorbents--role of grafting conditions on CO2 adsorption properties

Preparation of silica xerogel with high silanol content from sodium silicate and its application as CO2 adsorbent

Use of Ball Drop Casting and Surface Modification for the Development of Amine-Functionalized Silica Aerogel Globules for Dynamic and Efficient Direct Air Capture.

Influence of silica types on synthesis and performance of amine-silica hybrid materials used for CO2 capture

Sour Gas Adsorption on Silica Gels

CO2 Capture by the Amine-modified Mesoporous Materials

CO2 Adsorption by Polyamine-Based Protic Ionic Liquid-Functionalized Mesoporous Silica: Regenerability and Influence of Flue Gas Contaminants

Adsorption of Carbon Dioxide on Organically Functionalized Sba-16

Minimizing usage of silane coupling agent for amine-grafted mesoporous silica CO2 adsorbent

The Influence of Pore Size and Pore Structure of Silica-Based Material on the Amine-Modified Adsorbent for CO2 Capture

Modified mesoporous silica derived from bamboo leaf using cetyltrimethylammonium bromide and 3-aminopropyl triethoxysilane as CO2 adsorbent in biogas purification

Adsorption Separation of CO2/CH4 from Landfill Gas by Ethanolamine-Modified Silica Gel

Mesoporous silica-amine beads from blast furnace slag for CO2 capture applications

Amine-impregnated As-Synthesized Silicas for CO2 Capture: Experimental Study and Mechanism Analysis

A novel preparation of solid amine sorbents for enhancing CO2 adsorption capacity using alumina-extracted waste

Flexible, amine-modified silica aerogel with enhanced carbon dioxide capture performance