Abstract:Silica gel is a versatile support materials for upscaling silica supported solid amine sorbents for direct air capture and post‐combustion carbon capture. Point source CO2 capture (PSCC) is crucial for decarbonizing various industrial sectors, while direct air capture (DAC) holds promise for removing CO2 directly from the air. Sorbents play a critical role in both technologies, with their performances, efficiency, cost, etc., largely depending on which type is used (physical or chemical). Solid amine sorbents (SAS) employed in the chemical adsorption of CO2 are suitable for both PSCC and DAC. SAS offer significant advantages over liquid amines such as monoethanolamine (MEA), due to their ability to perform cyclic adsorption–desorption with much lower energy requirement. The environmental concern associated with MEA can be mitigated by SAS. Support materials have a significantly important role in stabilizing amine and enhancing stability and kinetics; varieties of support materials have been screened at a laboratory scale. One promising support material is a silica gel (SG), which is commercially available and attractive for designing cost‐effective sorbents for large‐scale CO2 capture. Various impregnation methods such as physical adsorption and covalent functionalization have been employed to functionalize silica surfaces with amines. This review provided a comprehensive critical analysis of SG‐based SAS for CO2 capture. We discussed and evaluated them in terms of their adsorption capacity, adsorption, and desorption conditions, and the kinetics involved in these processes. Finally, we proposed a few recommendations for further development of low‐cost, lower carbon footprint SAS for large‐scale deployment of CO2 capture technology.

Packet spreading, stabilization, and localization in superstrong fields.

Preparation and Co2 Sorption/Desorption of N-(3-Aminopropyl) Aminoethyl Tributylphosphonium Amino Acid Salt Ionic Liquids Supported into Porous Silica Particles

Silica Gel Supported Solid Amine Sorbents for CO2 Capture

Lithium based high temperature sorbent from copper slag: Synthesis and CO 2 capture performance

CO2 Adsorption by Polyamine-Based Protic Ionic Liquid-Functionalized Mesoporous Silica: Regenerability and Influence of Flue Gas Contaminants

Synthesis of mesoporous sodalite from coal-fired slag for CO2 capture

Synthesis of Highly Efficient CaO-Based, Self-Stabilizing CO2 Sorbents via Structure-Reforming of Steel Slag.

A green synthesis strategy for low-cost multi-porous solid CO 2 adsorbent using blast furnace slag

Continuous generation of mesoporous silica particles via the use of sodium metasilicate precursor and their potential for CO2 capture

Amine-functionalized disordered hierarchical porous silica derived from blast furnace slag with high adsorption capability and cyclic stability for CO2 adsorption

Utilizing silica fume and synthetically produced mesoporous silicas for simulated flue gas CO2 adsorption

Easily-synthesized and low-cost amine-functionalized silica sol-coated structured adsorbents for CO2 capture

Alumina-extracted residue-derived silica foams with ultra-large pore volume for highly superior post-combustion CO2 capture

Facile fabrication of mesoporosity silica as support for solid amine CO2 adsorbents with enhanced adsorption capacity and kinetics

Aerosol processing of low-cost mesoporous silica spherical particles from photonic industrial waste powder for CO2 capture

Fly ash-derived mesoporous silica with large pore volume for augmented CO 2 capture

A new strategy for CO 2 storage and Al 2 O 3 recovery from blast furnace slag and coal fly ash by employing vacuum reduction and alkali dissolution methods

Facile Synthesis of MgO Nanoparticle-Embedded Fe/N/S Codoped Carbon Materials from Oily Sludge for Efficient CO<sub>2</sub> Capture

Study of calcium-based CO2 sorbent with high cycling stability derived from steel slag and its anti-sintering mechanism

A novel synergistic method on potential green and high value-added utilization of blast furnace slag

Insight into the synergism of residual carbon and slag particles in coal gasification fine slag on porous composites preparation for CO 2 capture