Abstract:TiN coatings are commonly used in industry to impart improved friction and wear performance. It is widely recognised that the substrate plays an important role in determining the mechanical properties and wear resistance of such coatings. TiN coatings are usually applied to hard tool steels where there is substantial load support from the substrate. However, there are many applications where it may be desirable to apply the coatings to substrates with lower hardness or stiffness values than the conventional, hard tool-steel substrates that are commonly used. Coatings can still be effectively used in these applications. However, it is then critical to understand the transitions between where the deformation is contained solely in the coating and where it is a combination of coating/substrate properties that are important in determining the overall mechanical response of the system. This paper therefore reports on a systematic investigation of the effect of the substrate on the mechanical response using a range of mechanical testing techniques. A TiN coating was deposited using ion-assisted PVD onto a number of substrates with differing combinations of modulus and hardness [i.e. a range of Young's modulus (E) to yield stress (Y) E/Y ratios]. The mechanical properties of these coatings have been investigated using nanoindentation, microindentation and scratch testing, and the deformation was observed using scanning electron microscopy. In the microindentation tests, nested cracks were observed around the indentations. In the nanoindentation tests, the indentation response was found to be plasticity-dominated, with little evidence of cracking. The scratch tests showed that the scratch response was controlled by plastic deformation in the substrate, and that the friction coefficient increased as the depth of penetration into the sample increased. For the coatings here, it was observed that the indentation depth/coating thickness ratio required for the deformation to be contained within the coating was less than the usual t/10 ratio.

Substrate temperature effects on infrared emissivity of TiN x films

Structure, Electrical and Optical Properties of TiNx Films by Atmospheric Pressure Chemical Vapor Deposition

TiNx Thin Films for Energy-Saving Application Prepared by Atmospheric Pressure Chemical Vapor Deposition

Research on the Resistivity and Infrared Emissivity of Nonstoichiometric TiCrN Films

Relationship Between the Thermoelectric Properties and Infrared Emissivity of Nb-Doped TiO2

Study of optical and electrical properties of TiN thin films prepared by cathodic ion sputtering

Influence of Substrate Bias on Properties of TiN Films with X-ray Photoelectron Spectroscopy and Atomic Force Microscopy Studies

Electrical and optical properties of titanium nitride coatings prepared by atmospheric pressure chemical vapor deposition

The Structure and Properties of V Doped TiN Films Prepared at Various Temperatures

Investigation on Microstructure Evolution and Visible-Infrared Property of Vacuum-Heat-Treated TiN Film

Infrared enhanced absorption of TiNx nano films.

Study on infrared absorption characteristics of Ti and TiNx nanofilms

Study of Titanium Nitride for Low-E Coating Application

Effect of the Substrate Temperature on the Crystallization of TiO2 Films Prepared by DC Reactive Magnetron Sputtering

Effects of substrate temperature and bias voltage on mechanical and tribological properties of cosputtered (TiZrHfTa)N x films

Investigations in Anti-Impact Performance of TiN Coatings Prepared by Filtered Cathodic Vacuum Arc Method under Different Substrate Temperatures

Preparation of InN films at different substrate temperatures and the effect of operating temperatures on the carrier transmission characteristics of p-NiO/n-InN heterojunction

The effect of the substrate on the mechanical properties of TiN coatings

Reactive-sputter-deposited TiN films on glass substrates

Room temperature oxidation behavior of TiN thin films

From weak to strong-coupling superconductivity tuned by substrate in TiN films