Abstract:The present paper deals with an improvement of the strengthening technique consisting in the combined use of straps-made of stainless steel ribbons-and CFRP (Carbon Fiber Reinforced Polymer) strips, to increase the out-of-plane ultimate load of masonry walls. The straps of both the previous and the new combined technique pass from one face to the opposite face of the masonry wall through some holes made along the thickness, giving rise to a three-dimensional net of loop-shaped straps, closed on themselves. The new technique replaces the stainless steel ribbons with steel wire ropes, which form closed loops around the masonry units and the CFRP strips as in the previous technique. A turnbuckle for each steel wire rope allows the closure of the loops and provides the desired pre-tension to the straps. The mechanical coupling-given by the frictional forces-between the straps and the CFRP strips on the two faces of the masonry wall gives rise to an I-beam behavior that forces the CFRP strips to resist the load as if they were the two flanges of the same I-beam. Even the previous combined technique exploits the ideal I-beam mechanism, but the greater stiffness of the steel wire ropes compared to the stiffness of the steel ribbons makes the constraint between the facing CFRP strips stiffer. This gives the reinforced structural element a greater stiffness and delamination load. In particular, the experimental results show that the maximum load achievable with the second combined technique is much greater than the maximum load provided by the CFRP strips. Even the ultimate displacement turns out to be increased, allowing us to state that the second combined technique improves both strength and ductility. Since the CFRP strips of the combined technique run along the vertical direction of the wall, the ideal I-beam mechanism is particularly useful to counteract the hammering action provided by the floors on the perimeter walls, during an earthquake. Lastly, when the building suffers heavy structural damage due to a strong earthquake, the box-type behavior offered by the three-dimensional net of straps prevents the building from collapsing, acting as a device for safeguarding life.

Push-over analysis of a rubble full-scale masonry wall reinforced with stainless steel ribbons

Combined Strengthening Techniques to Improve the Out-of-Plane Performance of Masonry Walls

Nonlinear Behavior of a Masonry Subassemblage Before and After Strengthening with Inorganic Matrix-Grid Composites

In-Plane Lateral Response of a Full-Scale Masonry Subassemblage with and without an Inorganic Matrix-Grid Strengthening System

Experimental research on the shear behavior of brick walls reinforced with dry-connected steel plate frames

Experimental study on existing brick walls strengthened with high-strength steel wire mesh and polymer mortar

Wire Ropes and CFRP Strips to Provide Masonry Walls with Out-Of-Plane Strengthening

A 3D Pilot Simulation of Masonry Walls Retrofitted with Steel Strips Using a Novel Meso-Scale Damage-Plasticity Interface Model

Effectiveness of FRCM Reinforcement Applied to Masonry Walls Subject to Axial Force and Out-Of-Plane Loads Evaluated by Experimental and Numerical Studies

Nonlinear Static Analysis On Masonry Wall Strengthened With Reinforced Mortar Overlay

Experimental Research on the Behavior of Masonry Walls Reinforced with Dry-Connected Steel Plate Frames under Axial Compression

Analytical modeling of masonry load-bearing walls

Nonlinear masonry wall analysis of strengthened with high-strength wire cable and polymer mortar

Cyclic two-way out-of-plane testing of unreinforced masonry walls retrofitted using composite materials

Performance of Unreinforced Masonry Walls Retrofitted with Externally Anchored Steel Studs under Blast Loading

The Effectiveness of CFRP- and Auxetic Fabric-Strengthened Brick Masonry under Axial Compression: A Numerical Investigation

Experimental Study of Masonry Walls Strengthened with Cfrp

Experimental Study on Low Strength Brick Masonry Wall Strengthened with Self-compacting Concrete Wall

Experimental Study on Behavior of Bricklaying Strengthening Ribs Composite Wall under Low Cyclic Reversed Loading

A retrofitting technique using steel grids for existing masonry panels: a numerical and analytical study

Nonlinear finite and discrete element simulations of multi-storey masonry walls