Abstract:The bearing capacity of the vertical underpinning structure system is the key index in the design of top-down construction for adding a basement layer under existing buildings. The influence of the lateral restraint is the most significant under the dynamic construction excavation. For the problem of the bearing capacity of the existing engineering pile group under the top-down construction, the linear eigenvalue stability method was used first to study the influence of the lateral restraints such as the horizontal resistance of soil, the diameter of piles body, and the bending rigidity of the temporary steel bracing on its bearing capacity. The corresponding critical stability load and the effective length coefficient were then obtained. Then, based on the nonlinear extreme point stability method with the initial geometrical imperfection, the amplification range for the effective length coefficient was studied. Finally, based on the current Chinese Code Formula (JGJ 94-2008) and considering the influence of the compression buckling effect of the high cap pile, the present solution of the bearing capacity for the pile body was obtained and compared with the code solution. It turns out that the nonlinear bearing capacity of existing engineering piles group with initial imperfection is smaller than the critical stability load of the linear eigenvalue and increases with the increase of the imperfection amplitude, and the amplification range of the effective length coefficient is 1.10∼1.20. The present solution of the bearing capacity with the compression buckling effect is 1.10∼1.30 times of the code solution, which shows that the code solution is partial to safety, and the residual bearing can be properly considered in the design.

Development of partial factor design method on bearing capacity of pile foundations for Japanese Specifications for Highway Bridges

Design Method Reliability Assessment from an Extended Database of Axial Load Tests on Piles Driven in Sand

Assessment of design methods for axial bearing capacity of driven piles in clay

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

Experimental Studies on Seismic Behavior of Steel Pile-to-Pile-Cap Connections

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

A NEW CALCULATION METHOD FOR LARGE-DIAMETER-TUBULAR-PILE BEARING CAPACITY

Analysis of cast-in-situ tubular piles in soft foundation improvement at bridge approaches

SEISMIC DESIGN METHOD OF SMALL AND MEDIUM SPAN BRIDGE CONSIDERING BEARING FRICTION SLIPPING

Simplified Method for Evaluating Seismic Performance of Pile Foundation

Caisson-Bored Pile Composite Anchorage Foundation for Long-Span Suspension Bridge: Feasibility Study and Parametric Analysis

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Improved bridge capacity rating methods based on system reliability assessment

An Experimental Study on a Newly Proposed Connection Between a Steel Pier Base and a Cast-in-Place Pile with Manual Excavation for the Construction of Takaracho On-Ramp Viaduct at the Tokyo Metropolitan Expressway

Seismic Response and Failure Modes Analysis of Pile Foundations in Liquefiable Soils Using Various Design Criteria

A test on base bearing capacity of static drill rooted nodular pile

The 1996 Japanese seismic design specifications of highway bridges and the performance based design

Study on Bearing Capacity of the Existing Engineering Pile Group Without Lateral Displacement During Dynamic Top-Down Construction

Application of Pile Underpinning for Strengthening Design of Longgan Bridge

Behaviour of piled bridge abutments on soft ground: A design method proposal based on 2D elasto-plastic-consolidation coupled FEM