Abstract:Based on research into how static pressure piles sink in saturated cohesive soil, alterations caused by a rise in pore stress during the load process between the pile and the earth as well as the effects of a variation in valid radial thrust on the project are thoroughly studied. These changes are of great importance for the application and practice of practical projects. Microtest components are embedded on the surfaces of open and closed piles, and test research is conducted using a large-scale system and double-deck open and closed pipe piles. Finally, complete consideration is given to how variations in effective radial stress. Through this test, it was determined that as the pile’s buried depth gradually grows, so do the valid radial thrust and excess pore pressure. However, the quantity of the superfluous pore water stress for a closed pile is higher than for an open pile. And the higher half has substantially lower effective radial thrust and overall surplus pore stress than the lower part does. The pile penetration depth is constant, and the value of h/L of the pile shaft is also rising, the occurrence of “lateral pressure degradation” of earth load between pile and earth is becoming increasingly prominent. The maximum ratio of the excess pore stress to the valid soil pressure between the pile and earth contact is 62.1% for an exposed pile and 52.1% for a sealed pile. At the interface, the effective radial stress is about 3.76∼5.46 times that of the remaining pore water stress. Therefore, under changing pile penetration depths, the value of h/L will have an impact on the pile’s and the soil’s additional pore water pressure or excellent soil pressure. The test results have a significant impact on how static pressure piles are built and how bearing capacity is designed in real-world applications.

Assessment of design methods for axial bearing capacity of driven piles in clay

Database Assessment of Design Methods for Axial Bearing Capacity of Driven Piles in Sand

Design Method Reliability Assessment from an Extended Database of Axial Load Tests on Piles Driven in Sand

A New and Openly Accessible Database of Tests on Piles Driven in Sands

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Analysis of Axial Load-Transfer of Large-Diameter Cast-in-situ Tubular Pile

Analysis of Time-Dependent Bearing Capacity of A Driven Pile in Clayey Soils by Total Stress Method

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

A Simplified Calculation Method for Ultimate Bearing Capacity of Cast-in-Place Concrete Pipe Pile with Large Diameter in Clay Soil

Assessment of Cptu and Static Load Test Methods for Predicting Ultimate Bearing Capacity of Pile

Time-dependent bearing capacity of a jacked pile: An analytical approach based on effective stress method

A Full-Scale Field Study on Bearing Characteristics of Cast-in-Place Piles with Different Hole-Forming Methods in Loess Area

Finite Element Analysis of Lateral Bearing Capacity for Pile in Spatially Variable Clay

Field Tests on Bearing Characteristics of X-Section Pile Composite Foundation

Axial bearing behavior of super-long piles in deep soft clay over stiff layers

Assessment of Direct Cpt and Cptu Methods for Predicting the Ultimate Bearing Capacity of Single Piles

Research on conversion coefficient of cast-in-situ pile in clay in self-balanced loading test

Experimental Investigation on Jacked Pile-Sinking and Capacity-Induced Pore Pressure and Effective Radial Stress at the Pile-Clayey Soil Interface