Abstract:Carbon fiber-reinforced polymers (CFRPs) are being used extensively in modern industries that require a high strength-to-weight ratio, such as aerospace, automotive, motorsport, and sports equipment. However, although reinforcement with carbon fibers improves the mechanical properties of polymers, this comes at the expense of abrasive wear resistance. Therefore, to efficiently utilize CFRPs in dry sliding contacts, solid lubricant is used as a filler. Further, to facilitate the fabrication of objects with complex geometries, selective laser sintering (SLS) can be employed. Accordingly, in the present work, graphite-filled carbon fiber-reinforced polyamide 12 (CFR-PA12) specimens were prepared using the SLS process to explore the dry sliding friction and wear characteristics of the composite. The test specimens were aligned along four different orientations in the build chamber of the SLS machine to determine the orientation-dependent tribological properties. The experiments were conducted using a pin-on-disc tribometer to measure the coefficient of friction (COF), interface temperature, friction-induced noise, and specific wear rate. In addition, scanning electron microscopy (SEM) of tribo-surfaces was conducted to specify the dominant wear pattern. The results indicated that the steady-state COF, contact temperature, and wear pattern of graphite-filled CFR-PA12 are orientation-independent and that the contact temperature is likely to approach an asymptote far below the glass transition temperature of amorphous PA12 zones, thus eliminating the possibility of matrix softening. Additionally, the results showed that the Z-oriented specimen exhibits the lowest level of friction-induced noise along with the highest wear resistance. Moreover, SEM of tribo-surfaces determined that abrasive wear is the dominant wear pattern.

Friction wear characteristics of a femtosecond laser-patterned amorphous carbon thin film

Contact size effects on the friction and wear of amorphous carbon films

Ablation and Patterning of Carbon Nanotube Film by Femtosecond Laser Irradiation

Friction and Wear Properties of Aligned Film of Amorphous Carbon Nanorods on Anodic Aluminum Oxide Template in Vacuum

Comparative Study of the Tribology of Amorphous Carbon Films Via Magnetron Sputtering Depending on the Different Magnetic Field

Analysis of synergistic friction reduction effect on micro-textured cemented carbide surface by laser processing

Effects of Test Parameters on the Frictional Properties of Al/Diamond-like Carbon Core-shell Nanostructure-textured Surfaces

Atomic-Scale Understanding on the Tribological Behavior of Amorphous Carbon Films under Different Contact Pressures and Surface Textured Shapes

Microstructure and Tribological Performance of Self-Lubricating Diamond/tetrahedral Amorphous Carbon Composite Film

Investigation on microtribological behavior of thin films using friction force microscopy

Dry Friction and Wear Behavior of Laser-Sintered Graphite/Carbon Fiber/Polyamide 12 Composite

Combining Carbon Nanoparticle Coatings and Laser Surface Texturing for Enhanced Lubricity Under High Loads

Friction and Wear Behaviors of Surface-Modified Carbon Fabric/Epoxy Resin Composites

Micro-friction behavior of amorphous carbon films on porous AAO membrane synthesized by the pyrolysis of polyethleneglycol 400

Comparison of the Effect of Typical Patterns on Friction and Wear Properties of Chromium Alloy Prepared by Laser Surface Texturing

Synthesis and frictional properties of array film of amorphous carbon nanofibers on anodic aluminum oxide

Degradation analysis of tribologically loaded carbon nanotubes and carbon onions

Additional Tribological Effect of Laser Surface Texturing and Diamond-Like Carbon Coating for Medium Carbon Steel at Near Room Temperature

Experimental and numerical study of the effect of surface patterning on the frictional properties of polymer surfaces

On enhancement of fracture resistance of adhesive joints by surface micropatterning using a femtosecond laser

Chemical effects during the formation of various types of femtosecond laser-generated surface structures on titanium alloy