Abstract:Thin gauge nitrided grain-oriented silicon steel of 0.20 mm thickness and below shows pronounced surface effect during high temperature annealing. It is more prone to have anomalous microstructure and texture, leading to the decline of magnetic properties and its production is more difficult. Therefore, it is very important to find out the causes for the fluctuation in microstructure, texture, inhibitor state and magnetic properties so as to stabilize the product and reduce the production cost. In this paper, several samples showing different secondary recrystallization behaviors in production line are selected. The causes of different magnetic properties anomalies and the anomalous changes in texture were evaluated by means of a full high temperature annealing, the interrupted extraction test during secondary recrystallization and the determination of microstructure and texture of samples at each corresponding stage. The results show that the better magnetic properties correspond to the relatively high onset temperature of secondary recrystallization (1050 °C), larger primary grain size, strong primary recrystallization texture, thus forming a sharper Goss texture. The complete secondary recrystallization but poor magnetic properties correspond to the low onset temperature of secondary recrystallization (1020 °C), which is caused by the dual effects of the weak pinning of inhibitor and the smaller primary grain size leading to decrease in Goss texture sharpness. The reason of failed secondary recrystallization is attributed to the excessive pinning force of inhibitors, leading to the delayed onset temperature of secondary recrystallization or full fine-grained structure. In addition, low cold rolling reduction leads to low primary recrystallization texture intensity and the large number of {210} grains. However, the tendency of easy secondary recrystallization at low rolling reduction is suppressed by stronger inhibitor pinning and surface effect. The relationship between these anomalous phenomena and Als content, nitriding content, rolling reduction, primary recrystallization structure and texture was discussed.

Precipitation Behavior of AlN in High-Magnetic-Induction Grain-Oriented Silicon Steel Slab

Behaviors of Precipitation and Solution of AlN Inhibitor in High Magnetic Induction Grain-oriented Silicon Steel

Precipitation Behaviors of AlN Inclusion in High-Al Steel

Preparation of AIN Thin Film by DC Sputtering on SiO2/Si and Analysis of Microstructure

Characteristic of Precipitate Evolution during High Temperature Annealing in Grain-Oriented Silicon Steel

Inhibitors in High Magnetic Induction Grain-Oriented Silicon Steel

Influence of Nb Content on Precipitation, Grain Microstructure, Texture and Magnetic Properties of Grain-Oriented Silicon Steel

The Effect of Rare Earth Y on the Inhibitor Precipitation Behavior of Strip‐Cast Grain‐Oriented Silicon Steel

The impact of niobium on the microstructure, texture and magnetic properties of strip-cast grain oriented silicon steel

Effect of aluminum on secondary recrystallization texture and magnetic properties of grain-oriented silicon steel

The effect of Nb content on precipitates, microstructure and texture of grain oriented silicon steel

Solidification Structure and Segregation of High Magnetic Induction Grain-Oriented Silicon Steel

The Effect of Annealing Atmosphere on the Evolution Behavior of Inhibitors in Thin-Gauge Grain-Oriented Silicon Steel

Investigation of the Dissolution Behavior of AlN in CaO–Al2O3–MgO Refining Slag and CaO–Al2O3–F–Li2O–BaO Mold Flux

Origin of fine equiaxed grains in industrial low-temperature grain-oriented silicon steel normalized sheet and their influence on magnetic properties

Dependence of recrystallization behavior and magnetic properties on grain size prior to cold rolling in high silicon non-oriented electrical steel

A study of Laves phase in high Nb non-oriented silicon steel for electric automobiles

Phenomenon and Cause Analysis of Different Secondary Recrystallization Behaviors in Thin-Gauge Grain-Oriented Silicon Steels

Micro Characterization of Hot-Rolled Plate of Nb-Bearing Grain-Oriented Silicon Steel

AlN and Nb(C,N) Composite Precipitation Behaviors and Their Effects on Austenite Grain Growth in SCr420H High‐Temperature Carburized Gear Steel

Effect of Slab Reheating Temperature on Cold Rolling Texture Evolution of Nb-Containing Grain-Oriented Silicon Steel