Abstract:This paper is devoted to a review of the physical principle and effective methodology of thermal anemometry. Its uniqueness lies in the ability to realize a comprehensive high-frequency assessment of the dynamic and thermal state of the turbulent flow. It is worth noting that the American Nobel Prize winner in physics Richard Feynman called turbulence "the most important unsolved problem of classical physics", since there is no direct description of this phenomenon according to classical principles. Therefore, its physical interpretation is still considered one of the six most important mathematical issues of our time. Thus, despite its long history, thermal anemometry remains one of the leading techniques for studying of turbulent flow. Which has a significant impact on hydromechanical and heat-mass exchange processes, particularly in food technology. One of the most common types of thermal anemometry is the Hot-Wire anemometer, where a thin platinum wire is used as a sensor. The principle of operation of the anemometer is to maintain a constant heating of the wire while it is cooled by the surrounding flow of liquid or gas. Thus, the power required to compensate for the thermal state of the sensor wire correlates with the flow rate. The first part of the paper is devoted to the description of the physical principles of thermal anemometry, its advantages and limitations. In particular, special attention is paid to the mathematical interpretation of the heat transfer process between the incremental element of the sensor wire and the surrounding flow. After that, the paper provides a detailed analysis of the design features and practical application of various types of wire sensors. Finally, the last section discusses the calibration methodology and various approaches to the linearization procedure of the obtained calibration curves. Among them, the linearization method based on the Collis-Williams law deserves special attention, since it provides highly accurate interpolation of calibration data and takes into account the temperature compensation of the sensor.

The non-real-time explicit data analysis method of crossed hot-wire anemometer measurements including tangential cooling velocity correction

An Explicit Non-Real Time Data Reduction Method of Triple Sensors Hot-Wire Anemometer in Three-Dimensional Flow

Computing Mean Fields with Known Reynolds Stresses at Steady State

Obtaining the mean fields with known Reynolds stresses at steady state

A TEMPERATURE-GRADIENT CORRECTION METHOD FOR FILM COOLING EFFECTIVENESS MEASUREMENT USING ENDOSCOPE-BASED PSP TECHNIQUE

A RANS Numerical Study of Experimental Swash Flows and Its Bed Shear Stress Estimation

Software corrected hot wire thermal lag for the constant voltage anemometer featuring a constant bandwidth at the selected compensation setting

Phase-average Analysis of Three-Dimensional Vorticity and Temperature Dissipation Rate in the Near Field of a Heated Circular Cylinder Wake

Data Management Technique for Eddy-Covariance Calculation of the Air-Sea Fluxes

The dynamic response of a hot-wire anemometer: III. Voltage-perturbation versus velocity-perturbation testing for near-wall hot-wire/film probes

Combined hot-film anemometers for measuring flow speed vectors

Direct Numerical Simulation Of Turbulent Heat Transfer In An Axially Rotating Pipe Flow - Reynolds Shear Stress And Scalar Flux Budgets

Parameter-Free Data Reduction for Short-Time Hypersonic Heat Flux Measurements

Simulation of heating of the sensitive element of the heat flux sensors in a high-velocity flow under variable input conditions

A New Type of Hot-Wire/film Anemometer

Experimental Study of Hot-Sphere Anemometer Response in Stratospheric Environment

APPLICATION OF THERMAL ANEMOMETRY FOR TURBULENT FLOW ASSESSMENT

Temperature Compensation for Thermal Anemometers Using Temperature Sensors Independent of Flow Sensors

Response of hot-wire anemometry to transient flow induced by weak pressure waves

The Boundary Induced Error on the Measurement of Thermal-Conductivity by Transient Hot-Wire Method

A micro-hot-wire anemometry probe with elongated stubs for turbulent boundary layer measurements