Abstract:Fully developed turbulent pipe flow at Re=11300 as well as Re=5300 is measured by PIV using water as working fluid. Excellent agreement with DNS (Direct Numerical Simulation) by Satake (2000) is achieved by choosing optimum measurement parameters such as spatial resolution, time separation of two images, and number of samples. The test section is 6.7m long stainless steel pipe with transparent PIV measurement section attached seamlessly at the end. The measurement section consists of transparent acrylic circular pipe of 1mm thick and water jacket with square cross section. The water jacket reduces the image distortion due to the pipe curvature in almost entire area of the pipe cross section to negligible level except for the region very close to the pipe wall. For turbulent flow measurement using PIV, the requirement for spatial resolution is very severe in order to resolve the fluctuating velocity field especially at high Reynolds number. Therefore, higher magnification is chosen at the cost of the size of measurement area to assure enough spatial resolution. Consequently, the size of the measurement area is half of the pipe radius and measurement is performed at two regions which are called near-wall region and pipe center. For image analysis, the iterative multi-step cross-correlation algorithm with spatio-temporal gradient method for subpixel refinement is used. Detail of the algorithm can be found in Scarano (1999) and Sugii (2000). The smallest interrogation window is 8x16 pixels which corresponds to 249 x 585μm. The near-wall structure is observed from vector map of fluctuating in-plane velocity components and out-of-plane component of vorticity fluctuation. The shear layer structure is clearly shown by vorticity fluctuation and ejection and sweep motion is also observed. The mean velocity profile and statistics are calculated from 4000 samples of vector map by first taking temporal statistics and then spatial average along streamwise direction and compared with DNS in non-dimensional form using friction velocity. Since accurate measurement of friction velocity is essential for the comparison with DNS, using pressure gradient is not appropriate due to the relatively small pressure drop along the pipe. Therefore, curve-fitting method using near-wall turbulent model developed by McEligot (1984) is applied to calculate friction velocity from the velocity profile in buffer region.

Response of hot-wire anemometry to transient flow induced by weak pressure waves

The dynamic response of a hot-wire anemometer: III. Voltage-perturbation versus velocity-perturbation testing for near-wall hot-wire/film probes

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Improvement of the signal-to-noise ratio of the constant-temperature hot-wire anemometer using the transfer function

Flow Characterization of a PiezoElectric High Speed Valve

Hot-Wire-Based Estimation of Pressure Fluctuations in the Near Field of a Jet in the Presence of a Coflow

The 10 Hz dynamic response of a fluid-filled pressure monitoring system is a novel alternative to the fast flush test and indicative of unacceptable systolic pressure overshoot

The non-real-time explicit data analysis method of crossed hot-wire anemometer measurements including tangential cooling velocity correction

Highly Sensitive Hot-Wire Anemometry Based On Macro-Sized Double-Walled Carbon Nanotube Strands

Hot-wire based estimation of pressure fluctuations in the near field of a jet in the presence of a co-flow

Simulation of heating of the sensitive element of the heat flux sensors in a high-velocity flow under variable input conditions

Basic nanoconvective flow for transient hot wire experimental method

Flow-Independent Thermal Conductivity and Volumetric Heat Capacity Measurement of Pure Gases and Binary Gas Mixtures Using a Single Heated Wire

AeroMEMS Sensor with Integrated Pressure and Hot-Wire Sensor for High-Frequency Transition Detection

PHASE DETECTION AIDED THERMOMETRY AND ITS APPLICATION TO NATURAL CONVECTIVE SUBCOOLED FLOW BOILING IN A NARROW GAP

Direct Numerical Simulation of MHD Flow with Electrically Conducting Wall

Study on new gas flow sensor based on hot-film probe

Turbulent Pipe Flow in a Transverse Magnetic Field: A Comparison Between PIV Measurement and DNS

Heat transfer enhancement on thin wires in superfluid helium forced flows

Numerical Study on Heat Transfer of an Impinging Turbulent Plane Jet with Confined Wall.

Measurements of turbulence statistics and near-wall structure of fully developed pipe flow at high Reynolds number