Abstract:A heat exchanger is an important component where high-temperature hot air and normal-temperature water exchange heat. The heat exchange area of the finned tube heat exchanger is calculated by the rated working conditions. However, with the decrease of the heat storage temperature, the hot air temperature at the outlet of the thermodynamic energy storage device changes in a large range, directly affecting the heat exchange capacity and efficiency of the finned tube heat exchanger. This paper's three-dimensional model is established. The heat exchanger of the finned tube is designed according to the temperature of the outlet section and the return section temperature of the heat storage system. The thermodynamic physical parameter property and characteristics of which heat exchanger's finned tube in the air's velocity range of 1∼10 m/s are simulated by fluent software. The velocity, temperature, pressure, and heat exchanger coefficient distribution characteristics at different positions along the airflow direction are obtained. The simulation results show that the mean flow velocity is 2.0 m/s and 5.0 m/s at the inlet cross-section. The average temperature difference between the inlet and outlet is 69.5 K and 100.5 K, respectively. The fin surface temperature difference between the first and eighth rows of finned tubes is 12.5 K and 14.4 K, respectively. The air pressure loss at the air channel inlet's section and outlet's section is 16.1 Pa and 69.4 Pa, respectively. When the inlet flow rate change from starting at 1.0 m/s and ending at 10.0 m/s, the tube's wall coefficient of heat transfer, which is the second level of finned tubes, only increases by 1.8 times. The tube's wall coefficient of heat transfer of the eighth level of finned tubes increases by the maximum, to 5 times the original, but the heat energy exchange capacity of which the second level of finned tubes is always the strongest.

Simulation of heating of the sensitive element of the heat flux sensors in a high-velocity flow under variable input conditions

Observation of Heat Transfer in Oscillating Flow Within A Circular Channel

Simulation And Analysis On Heat Transfer In Laminar Oscillatory Flow In-Tube

Investigation of Oscillation Modes in a High-Speed Flow with Heat Supply. II. Numerical Simulation

Numerical Simulation of Turbulent Flow and Heat Transfer in Multi‐channel, Narrow‐gap Fuel Element

Numerical Simulation of Cavitation Flow under High Pressure and Temperature

High-Pr Heat Transfer in Viscoelastic Drag-Reducing Turbulent Channel Flow

Direct Numerical Simulation for Laminarization of Turbulent Forced Gas Flows in Circular Tubes with Strong Heating

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Conjugate heat transfer in spatial laminar-turbulent transitional channel flow

Numerical Simulation of Heat Transfer Characteristics of Finned Tube Heat Exchanger at Different Flow Velocities

Experiments on the Transient Heat Transfer of Minichannel Heat Sink under High Heat Flux Density in an Enclosed Loop

Velocity and Temperature Simulation of a New Air Flow Sensor

High-Frequency Heat Flux Sensor Calibration and Modeling

Numerical Simulation of Transient 3-D Turbulent Heated Jet into Crossflow in a Thick-Wall T-junction Pipe

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Finite element simulation of Soret-Dufour and conjugate heating effects on mixed convective heat absorbing hydromagnetic Casson fluid flow with suction/blowing from flat semi-infinite vertical porous plate

Interferometric Measurement and Numerical Comparisons of Supersonic Heat Transfer Flows in Microchannel

Numerical simulations of heat transfer in plane channel flow

Simultaneously developing flow and heat transfer in circular and parallel-plates microchannels with velocity slip and temperature jump

Effect of heat losses in the temperature transducer in measurements in hotshot wind tunnels