Abstract:This paper presents a wearable anemometer for detecting wind absolute orientation and wind speed, as well as attitude and heading angles by incorporating a micro homemade thermal flow vector sensor with commercial triaxial micro accelerometer and triaxial micro magnetometer. The thermal flow vector sensor is comprised of three roundabout Pt hot-films uniformly distributed in a circle that is fabricated on a polyimide substrate. The flow sensor detects flow speed and flow relative angle in the body coordinate system, which is calculated from the heating powers of three hot-films that are operated in constant temperature difference circuits. The flow relative angle is further converted to the wind absolute orientation in the geographic coordinate system by means of the attitude and heading angle detected by using the triaxial accelerometer and triaxial magnetometer. The power consumption of the whole anemometer is about 400 similar to 500 mW under a wind blowing of 0 similar to 20 m/s. Using a rechargeable lithium battery with a capacity of 600 mAh, the anemometer can he continuously worked for about 4 h. Wind experimental results demonstrate that the root mean square (rms) error of the wind speed measurement reaches 0.17 m/s in the range of 0 similar to 18.9 m/s, the rms errors of wind relative angle and absolute orientation reach 2.79 degrees and 3.22 degrees, respectively, in the range of 0 similar to 360 degrees. Attitude and heading experimental results illustrate that the rms errors of heading and roll measurements reach 0.42 degrees and 0.15 degrees, respectively, in the range of -180 degrees similar to 180 degrees, and the rms error of pitch reaches 0.13 degrees in the range of -90 degrees similar to 90 degrees.

Combined hot-film anemometers for measuring flow speed vectors

Measuring Flow Velocity Distribution in Microchannels Using Molecular Tracers

A flexible integrated micromachined hot-film sensor array for measuring surface flow vector

Research on Flow Sensor System Integrated with Wing of Micro Air Vehicle

Anemometer For Detection Of Very Low Speed Air Flow With Three-Dimensional Directionality

A novel five-wire micro anemometer with 3D directionality for low speed air flow detection and acoustic particle velocity detecting capability

ANEMOMETER WITH THREE-DIMENSIONAL DIRECTIONALITY FOR DETECTION OF VERY LOW SPEED AIR FLOW AND ACOUSTIC PARTICLE VELOCITY DETECTING CAPABILITY

Wind Speed Measurement by an Inexpensive and Lightweight Thermal Anemometer on a Small UAV

Design of an Array of Piezoresistive Airflow Sensors Based on Pressure Loading Mode for Simultaneous Detection of Airflow Velocity and Direction.

Wearable Anemometer with Multi-Sensing of Wind Absolute Orientation, Wind Speed, Attitude, and Heading

Fast-response hot-wire flow sensors for wind and gust estimation on UAVs

Flexible Micro Flow Sensor for Micro Aerial Vehicles

Air–water two-phase flow measurement using a Venturi meter and an electrical resistance tomography sensor

A Low-Cost Integrated Micro System for Flow Velocity and Direction Measurement

A two-dimensional flow sensor with integrated micro thermal sensing elements and a back propagation neural network

Neural Network-Based Airflow Vector Sensor Using Multiple MEMS Differential Pressure Sensors

Hybrid System for Airspeed Measurement Using Dual MEMS Sensors

Aircraft flight parameter detection based on a neural network using multiple hot-film flow speed sensors

Airfoil Anemometer With Integrated Flexible Piezo-Capacitive Pressure Sensor

Reconstruction of the magnetic field in the measuring volume of an electromagnetic flow sensor