Abstract:Accurate prediction of aerodynamic forces in real-time is crucial for autonomous navigation of unmanned aerial vehicles (UAVs). This paper presents a data-driven aerodynamic force prediction model based on a small number of pressure sensors located on the surface of UAV. The model is built on a linear term that can make a reasonably accurate prediction and a nonlinear correction for accuracy improvement. The linear term is based on a reduced basis reconstruction of the surface pressure distribution, where the basis is extracted from numerical simulation data and the basis coefficients are determined by solving linear pressure reconstruction equations at a set of sensor locations. Sensor placement is optimized using the discrete empirical interpolation method (DEIM). Aerodynamic forces are computed by integrating the reconstructed surface pressure distribution. The nonlinear term is an artificial neural network (NN) that is trained to bridge the gap between the ground truth and the DEIM prediction, especially in the scenario where the DEIM model is constructed from simulation data with limited fidelity. A large network is not necessary for accurate correction as the linear model already captures the main dynamics of the surface pressure field, thus yielding an efficient DEIM+NN aerodynamic force prediction model. The model is tested on numerical and experimental dynamic stall data of a 2D NACA0015 airfoil, and numerical simulation data of dynamic stall of a 3D drone. Numerical results demonstrate that the machine learning enhanced model can make fast and accurate predictions of aerodynamic forces using only a few pressure sensors, even for the NACA0015 case in which the simulations do not agree well with the wind tunnel experiments. Furthermore, the model is robust to noise.

Aircraft flight parameter detection based on a neural network using multiple hot-film flow speed sensors

Aircraft aerodynamic parameter detection using micro hot-film flow sensor array and BP neural network identification

Intelligent perception of tandem flapping wings' flow field environment with sparse detectors

Neural Network-Based Airflow Vector Sensor Using Multiple MEMS Differential Pressure Sensors

Artificial Hair Sensor Placement Optimization on Airfoils for Angle of Attack Prediction

Research on UAV Flight Parameter Identification Method Based on Launch Force and Airspeed

Estimation of Airflow Parameters for Tail-Sitter UAV through a 5-Hole Probe Based on an ANN

Microphones as Airspeed Sensors for Unmanned Aerial Vehicles

Parallel crosschecking neural network based fault-tolerant flight parameter estimation and faulty sensor identification

Sparse Flow Sensor Placement Optimization for Flight-by-Feel Control of 2D Airfoils

Research on Flow Sensor System Integrated with Wing of Micro Air Vehicle

Machine learning enhanced real-time aerodynamic forces prediction based on sparse pressure sensor inputs

Machine-Learning-Enhanced Real-Time Aerodynamic Forces Prediction Based on Sparse Pressure Sensor Inputs

Combined hot-film anemometers for measuring flow speed vectors

Research on Embedded Atmospheric Measurement Method Based on Three-point Method

Multisensor Data-Fusion-Based Approach to Airspeed Measurement Fault Detection for Unmanned Aerial Vehicles

Touch the Wind: Simultaneous Airflow, Drag and Interaction Sensing on a Multirotor

Development of a Real-Time In-Flight Ice Detection System via Computational Aeroacoustics and Bayesian Neural Networks

Fast simulation of airfoil flow field via deep neural network

AIRCRAFT MOTION PARAMETER ESTIMATION VIA MULTIPATH TIME-DELAY USING A SINGLE GROUND-BASED PASSIVE ACOUSTIC SENSOR

A two-dimensional flow sensor with integrated micro thermal sensing elements and a back propagation neural network