Abstract:When an insulating material is subjected to electron irradiation, it produces a secondary emission the yield of which varies from a few percent to very high values (up to 24 per incoming electron) depending on the material and the experimental conditions. If the secondary electron emission yield is less than one, a net negative charge remains trapped in the sample. In this case, the study of the electric charges trapping properties of the material becomes possible. This article describes how it is possible to use a secondary electron microscope (SEM) as a device to perform such a study. In Sec. II, the effect of a net negative trapped charge resulting (from the injection of typically 50 pC) on the imaging process of the SEM has been described. It has been shown that when the trapped charge is high enough, it acts as a mirror reflecting the incoming electron beam which is deflected somewhere in the vacuum chamber of the microscope. A global qualitative description of the image displayed on the screen is first presented. Then electron trajectories are quantitatively studied by using the Rutherford scattering cross section in the case of a point charge. When the charge is extended, a numeric simulation has been done in order to predict the validity range of the previous model. Once the trajectories have been calculated, the connection between the remarkable elements of the image and the quantity of trapped charges has been established. Moreover, this technique allows one to study the lateral dimension of the trapped charge zone and to measure the surface potential. In Sec. III, the discussion is first focused on some precautions to be taken concerning the sample preparation before the experiment is performed. It has been shown that surface defects due either to contamination layers or machining change the trapping properties of single-crystals ceramics such as MgO and Al2O3. A cleaning procedure is proposed that consists of annealing the sample at 1500 °C for 4 h in order to heal the crystalline defects and a heating at 400 °C in the vacuum chamber of the SEM to remove the contamination layers. Finally, the effect of the temperature on the trapping properties of pure and chromium doped sapphire has been studied in relation with the chromium concentration. It is shown that temperature behavior of trapping is in relation with the chromium concentration. In the pure sapphire trapping is activated below −16 °C, in 500 ppm rubis it is below −9.5 °C due to isolated chromium atoms, and in the 8000 ppm rubis the critical trapping temperature rises to 3.7 °C due to Cr3+ pairs. The interpretation of the role played by chromium on trapping is based on the experimental study of the fluorescence of chromium atoms and pairs as a function of concentration.

Space charge measurement in a dielectric material after irradiation with a 30 kV electron beam: Application to single-crystals oxide trapping properties

Atomic Investigation on the Facet‐Dependent Melting of Ceramic Nanostructures Via in Situ Electron Irradiation

Elimination of the charge effect on zirconia coatings using a focused ion beam for characterization of the three-dimensional microstructure

Total-Ionizing-Dose Effects on Al/SiO2 Bimorph Electrothermal Microscanners

Review of Charge Deposition Characteristics and Trap Parameters of Dielectric in Space Electron Radiation Environment

Sample Thickness Effect Of Thermal Vibration Correction Within X-Ray Dynamical Theory For Germanium-Doped Silicon

Analysis of electron transfer between electron irradiated metallic ball and insulators in vacuum: A specific alternative to the mirror method

Electron-beam-induced charging of an Al2O3 nanotip studied using off-axis electron holography

Imaging the Photoionization of Individual CdSe/CdS Core−Shell Nanocrystals on N- and P-Type Silicon Substrates with Thin Oxides

Measurements of the Secondary Electron Emission of Some Insulators

A Monte Carlo Modeling on Charging Effect for Structures with Arbitrary Geometries

Trapping electrons in semiconductor air bubbles: A theoretical approach

Numerical Simulations of Charge Trapping in Germanium Strip Detectors

Surface Trapping Parameters of Solid Dielectrics: Novel Measurement Method and Insulation Condition Characterization

Influence of gamma-irradiation sterilization on the structural defects of sapphire single crystals (alpha-Al(2)O(3))

Charge exchange of slow highly charged ions from an electron beam ion trap with surfaces and 2D materials

Suppression of Secondary Electron Emission by Micro-Trapping Structure Surface

Evaluating the performance of ionic liquid coatings for mitigation of spacecraft surface charges

Heating rate and electrode charging measurements in a scalable, microfabricated, surface-electrode ion trap

Measurement of electron beam induced sample heating in SEM experiments

Preliminary characterization of a surface electrode Paul trap for frequency metrology