Porous mullite nanopowder for slurry preparation of material direct writing by sol-gel method

Hisao Suzuki,Yusaku Takai,Naoki Wakiya,Yoshitugu Tomokiyo
DOI: https://doi.org/10.14723/tmrsj.32.1173
2007-01-01
Transactions of the Materials Research Society of Japan
Abstract:Nanoporous ultrafine powders of mullite with a stoichiometric composition were successfully prepared by controlling the agglomeration behavior of the sols prepared from molecular-designed precursor solution. Aging of the sols in the solvents with low dielectric constant, such as butylalcohol, resulted in the coarse flocculation of the primary colloidal particles to form nanoporous ultrafine precursor powders for the slurry to apply material direct writing. These precursor nanopowders crystallized into orthorhombic mullite powder with high surface area even after high temperature calcination at 1400 °C. The nanoporous structure of the precursor powder was successfully maintained in the thin films deposited by spin-coating from the sol of the nanoporous mullite precursor powders calcined at 800 wit oC with different oxide concentrations. As a result, nanoporous mullite ceramic thin films with a stoichiometric composition was prepared. The nanostructure of the resultant porous thin films were observed by AFM to show the relatively smooth surface with RMS values less than 3 nm.
What problem does this paper attempt to address?