Abstract:The low-cycle fatigue of strongly-textured Mg alloys is dominated mainly by an alternation of twinning-detwinning process, which poses a great challenge to conventional constitutive models. As a result, a good reproduction of both mechanical response and deformation behavior often fails in previous simulations, in particular for high strain amplitudes. In the present study, the numerical simulations of low-cycle fatigue behavior of an Mg AZ31 plate with a ± 2% axial strain amplitude along the rolling direction were conducted, using a modified crystal-plasticity based on the finite strain elastic-viscoplastic self-consistent model containing twinning and detwinning mechanisms (EVPSC-TDT), and the results were compared with the mechanical response and deformation behavior determined by a real-time in-situ neutron diffraction. The simulations well predict the hysteresis loops and cyclic-hardening responses throughout the whole fatigue life (80 cycles), along with the evolution of the maximum twin volume fraction and residual twins. For the first time, the evolution of lattice strain throughout the whole fatigue life was calculated, and the results are in good accordance with that determined by neutron diffraction. The present study strongly demonstrates that the EVPSC-TDT model is very effective for modeling the low-cycle fatigue behavior of Mg alloys. More details about the evolution of the maximum twin volume fraction with fatigue cycles are found, an increase from 1st to 2nd cycle, followed by a decrease from 2nd to 20th cycle and a secondary increase after 20th cycle. This finding corrects the previous opinion that the maximum twin volume fraction increases at the initial stage and tends to be saturated at the late stage. Combining the results of simulations and neutron diffractions, the corresponding reasons are explained. Afterward, the mechanisms of the cyclic-hardening behavior at tension stage and compression stage are revisited, and some new insights are provided.

Quantitative Investigation on the Slip/Twinning Activity and Cracking Behavior During Low-Cycle Fatigue of an Extruded Mg-3Y Sheet

A Statistical Analysis of Compressive Deformation Mechanisms in an Extruded Mg–3Y Sheet

The deformation modes and transferability during low-cycle fatigue of Mg and Mg–3Y alloy

Anisotropic cyclic deformation behavior of an extruded Mg-3Y alloy sheet with rare earth texture

Statistical Investigation of Deformation Mechanisms in Rolled Mg Sheet During Compression

Quantitative analysis of the deformation modes and cracking modes during low-cycle fatigue of a rolled AZ31B magnesium alloy: The influence of texture

Statistical Analysis Of Grain-Scale Effects Of Twinning Deformation For Magnesium Alloys Under Cyclic Strain Loading

Tension-compression Asymmetry and the Underlying Slip/twinning Activity in Extruded Mg–Y Sheets

Quantitative Investigation on the Deformation Modes and Cracking Behavior During Cyclic Torsional Loading of Extruded Pure Mg and Mg-3y Alloy

Effects of Y on the Deformation Mechanisms of Extruded Mg-Y Sheets During Room-Temperature Compression

Quantitative Study on Slip/twinning Activity and Theoretical Critical Shear Strength of Mg Alloy with Y Addition

Quantitative investigation on the {10–12} twinning-detwinning behavior and twinning transfer of an extruded Mg-2.8Y sheet during compression-tension loading via quasi-in-situ EBSD observation

In Situ Monitoring of Dislocation, Twinning, and Detwinning Modes in an Extruded Magnesium Alloy under Cyclic Loading Conditions

Damage evolution of extruded magnesium alloy from deformation twinning and dislocation slipping in uniaxial stress-controlled low cycle fatigue

In-situ Analysis of Microscopic Plastic and Failure Behaviors of Extruded Magnesium Alloy

In-situ Analysis of the Slip Activity During Tensile Deformation of Cast and Extruded Mg-10Gd-3Y-0.5Zr (wt.%) at 250°C

In-Situ Analysis of the Tensile Deformation Modes and Anisotropy of Extruded Mg-10gd-3y-0.5zr (wt.%) at Elevated Temperatures

Plastic Strain Accommodation and Crack Initiation in a Randomly-Oriented Mg-8y-1zr Magnesium Alloy During Accumulated Tensile Deformation

Role of Yttrium Content in Twinning Behavior of Extruded Mg-Y Sheets under Tension/compression

Identification and Analysis of Anomalous {101‾2} Twins in an Extruded Mg-2wt%Y Alloy Sheet During Uniaxial Tensile Loading

Crystal plasticity modeling of low-cycle fatigue behavior of an Mg-3Al-1Zn alloy based on a model, including twinning and detwinning mechanisms