Abstract:In the hogging moment regions of steel-concrete composite beams that have been widely used in bridges and buildings nowadays, the concrete slabs are vulnerable to cracks and the connection interfaces are subject to debonding. These damages could substantially reduce the stiffness, strength and durability of the beams. Comprehensive and quantitative structural health monitoring of steel-concrete composite beams is in great demand. To this end, a novel framework was developed in this study for damage location, quantification and characterization of steel-concrete composite beams using acoustic emission (AE) measurements. The damage-induced AE sources were located more accurately based on empirical wavelet transform (EWT), Akaike information criterion (AIC) and genetic algorithm (GA), where EWT and AIC together helped to determine the exact arrival times of AE waves in the presence of serious attenuation, reflection, scattering and dispersion of AE waves and high operational noise of the structure. With the coordinates of located AE events, the macrocrack and debonding surfaces were estimated by hybrid hierarchical-k-means clustering analysis. After that, the microcracking modes and orientations were diagnosed based on moment tensor analysis that made use of the coordinates of AE events and the P-wave first motions. Through the reversed four-point bending test of steel-concrete composite beams, the proposed framework was proved to be able to detect both concrete cracks and interface debondings. Multiple damages of different types could be accurately located and quantified. The dominant damage mechanism of cracks in the concrete slabs was found to be tensile-mode microcracking, and the interface debonding was also primarily caused by tensile stress-related vertical uplift.

Analysis of Low-Temperature Damage of Reinforced Concrete Beams Using Acoustic Emission Parameters

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

Influence of Longitudinal Bar Corrosion on Impact Behavior of RC Beams

Cracking Mechanism of Corroded Reinforced Concrete Column Based on Acoustic Emission Technique

To Monitor Fracture Behaviors in Four-Point Cyclic Bending Tests of Low-Activated High Alumina Concrete and Standard Concrete RC Beams Using Acoustic Emission Technique

Acoustic Emission Study on the Damage Evolution of a Corroded Reinforced Concrete Column under Axial Loads

Acoustic Emission Analysis of Corroded Reinforced Concrete Columns under Compressive Loading.

Structural behaviors evaluation of RC beam under frost damage - A methodology with meso-macro material/bond simulation and integrating into structural analysis

Acoustic Emission Monitoring of Progressive Damage of Reinforced Concrete T-Beams under Four-Point Bending

Experimental and Analytical Investigation of Crack Spacing and Width for Overlaid RC Beams at Elevated Temperatures

Cracking Behavior of Cfrp Laminate-Strengthened Rc Beams with Premechanical and Postmechanical Environmental Damage

Coupled Thermo‐hydro‐mechanical Analysis of Reinforced Concrete Beams under the Effect of Frost Damage and Sustained Load

Study on Degradation Regularity of Bearing Capacity of RC Beams under Corrosive Conditions

Damage location, quantification and characterization of steel-concrete composite beams using acoustic emission

Damage in carbon fiber-reinforced concrete, monitored by both electrical resistance measurement and acoustic emission analysis

Intensity Analysis Method of Acoustic Emission Signals for the Damage Monitoring of Post-Tensioned Concrete Beams

Acoustic Emission Monitoring of Concrete Columns and Beams Strengthened with Fiber Reinforced Polymer Sheets

Damage assessment of precast reinforced concrete beam-column connections using AE technology

Damage evaluation and failure mechanism analysis of steel tube confined reinforced-concrete columns by acoustic emission technology

In-line monitoring of cryogenic three-point bending test of fiber-reinforced composites using acoustic emission

Acoustic emission monitoring of damage modes in reinforced concrete beams by using narrow partial power bands