Thermal stability enhancement of perovskite MAPbI3 film at high temperature (150 °C) by PMMA encapsulation

Yew Hang Soo,Soo Ai Ng,Yew Hoong Wong,Chai Yan Ng

DOI: https://doi.org/10.1007/s10854-021-06041-y

2021-05-05

Abstract:Methylammonium lead iodide (MAPbI₃) is a perovskite material functioning as a light-absorbing layer in a perovskite solar cell (PSC). However, many works reported the poor thermal stability of MAPbI₃, which hindered the direct annealing of low-temperature processed (≤ 150 °C) metal oxide sols as a charge transport layer (CTL) on top of it. In this work, a poly(methyl methacrylate) (PMMA) layer was spin coated onto the ambient air-prepared MAPbI₃ film to act as an encapsulation layer. The encapsulated MAPbI₃ film was annealed at 150 °C for 1–5 h. The PMMA passivated the grain boundary defects located at film/air interface and extended the onset of thermal degradation time up to 3 h, which is significantly longer than the annealing time required for metal oxide sol CTLs. The MAPbI₃ phase also remained dominant even after 5 h of annealing, showing its high thermal stability. With this thermal stability enhancement, it would open a pathway for the fabrication of PSCs with metal oxide sol CTLs that are low cost, high stability, as well as low temperature processed (≤ 150 °C).

engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied