Abstract:Research interest in thin-film transistor (TFT)-based flexible electronics for next-generation foldable and rollable displays is increasing, centering on flexible plastic substrates such as polyethylene terephthalate (PET), polyethylene naphthalate (PEN), and polyimide (PI). For flexible electronics using plastic substrates, it is important to select suitable semiconductor materials that can be deposited at low substrate temperature. Metal oxide (MO) semiconductors such as indium-gallium-zinc oxide (IGZO), zinc oxide (ZnO) are attracting attention as suitable candidates for plastic substrate electronics because of their higher mobility and optical transmittance than hydrogenated amorphous silicon (a-Si:H). In addition, since it can be processed at a lower temperature than low-temperature polysilicon (LTPS), it can be easily applied to flexible plastic substrates. One of the greatest advantages of MO is that it can be easily fabricated by conventional semiconductor processing methods such as sputtering, atomic laser deposition, and solution processes. Among them, solution-processed deposition method is particularly advantageous in terms of manufacturing efficiency because it does not require a separate vacuum system, and can efficiently utilize raw materials, so the fabrication cost is inexpensive. In particular, spray pyrolysis can guarantee environmental stability, high mobility, and large area production than other solution processes. In this work, we developed the high-performance, flexible a-IGZO/Al 2 O 3 TFTs using spray pyrolysis fabricated on the flexible PI substrate. In a previous study, we developed a method to reduce curling and electrostatic discharge (ESD) damage to PI substrates by using a mixture of carbon nanotubes (CNTs) and graphene oxide (GO) between carrier glass and PI substrate. Therefore, it was possible to mechanically detach the TFTs on PI substrate and handle them easily even after detachment. The spray-pyrolyzed Al 2 O 3 film is one of the high-k dielectric materials, which can lower the operating voltage, so the low-power consumption of the TFT backplane can be realized. The flexible spray-pyrolyzed a-IGZO/Al 2 O 3 TFT exhibits the field-effect mobility (μ FE ) of 9.75 cm 2 V −1 s −1 , threshold voltage (V TH ) of −0.8 V, subthreshold swing (SS) of 0.29 V dec −1 , and on/off current ratio of 6.2 × 10 7 . Even without TFT passivation layer, it shows environmental stability. The TFTs show robust electrical performance even under tensile strain with a bending radius of 1 mm. In addition, it showed stable electrical characteristics even in the repeated bending test of 30,000 cycles under compressive strain with a bending radius of 1 mm. This is due to fewer defects resulting from the smooth interface of the a-IGZO film and the Al 2 O 3 film deposited through spray pyrolysis. Therefore, spray-pyrolyzed a-IGZO/Al 2 O 3 TFT fabricated on PI substrate is a promising candidate for next-generation foldable display application. Figure 1

Extremely foldable LTPS TFT backplane using blue laser annealing for low‐cost manufacturing of rollable and foldable AMOLED display

Blue laser diode annealing-enhanced bottom-gate low-temperature Poly-Si thin-film transistors

57‐2: High performance LTPS TFT Backplane Using Blue Laser Diode Annealing for Mini/Micro LED Display

Flexible TFT backplane development for extremely small bending radius with organic ILD and novel TFT structures

24‐4: Flexible AMOLED Based on Oxide TFT with High Mobility

Flexible Amorphous Indium-Gallium-Zinc Oxide Thin-Film Transistor with Aluminum Oxide Gate Insulator on Polyimide Substrate By Spray Pyrolysis for Foldable Display

Low-temperature solution-processed flexible metal oxide thin-film transistors via laser annealing

Blue Laser Diode Annealed Top-Gate Low Temperature Poly-Si TFTs With Low Resistance of Source/Drain From Deposited n + Layer

Single-crystalline silicon nanomembrane thin-film transistors with anodized aluminum oxide as a gate dielectric on rigid and flexible substrates

Letter: A low-cost low-temperature thin-film-transistor backplane based on oxide semiconductor

TFT Display Backplane Technology Based on Low-Temperature Polysilicon-Oxide Semiconductor Hybrid Integration

Implementing Room‐Temperature Fabrication of Flexible Amorphous Sn–Si–O TFTs via Defect Control

A flexible AMOLED display on the PEN substrate driven by oxide thin-film transistors using anodized aluminium oxide as dielectric

Novel mobile TFT‐LCDs based on SLS technology

Oxide TFT with multilayer gate insulator for backplane of AMOLED device

37.1: <i>Invited Paper:</i> A Room‐Temperature Manufacturing Strategy: Nd:AIZO/Al<sub>2</sub>O<sub>3</sub> Thin‐Film Transistor

Self-Aligned Elevated-Metal Metal-Oxide Thin-Film Transistors for Displays and Flexible Electronics

High‐performance Nd: AIZO/Al2O3 dual active layer design without thermal annealing: high‐speed electron transport and defect modification in thin film transistors

Flexible Amorphous Oxide Thin-Film Transistors on Polyimide Substrate for AMOLED

Fabrication of Flexible Amorphous Indium-Gallium-Zinc-Oxide Thin-Film Transistors by a Chemical Vapor Deposition-Free Process on Polyethylene Napthalate

Improvement of Device Characteristics of Low Temperature IGZO Thin-film Transistors through Laser Post Annealing