Characterization and application of niobium-doped titanium dioxide thin films prepared by sol–gel process

Gustavo Henrique M. Gomes,Magnum A. M. L. de Jesus,André S. Ferlauto,Marcelo M. Viana,Nelcy D. S. Mohallem
DOI: https://doi.org/10.1007/s00339-021-04781-6
2021-08-01
Applied Physics A
Abstract:Pure and Nb-doped TiO2 crystalline thin films with different molar ratios of niobium were produced by sol–gel process using the dip-coating method. The results of X-ray diffractometry analysis using Rietveld refinement confirmed the presence of the anatase phase and the partial substitution of Ti4+ by Nb5+ in the [TiO6] octahedra, since changes in the lattice parameters, crystalline strain and crystallite size were observed. The occupation of niobium atoms at the Ti4+ sites and an increase in the oxygen content were also determined. Atomic force microscopy analyses showed a uniform and homogeneous surface morphology and high-resolution transmission microscopy showed agglomerated nanoparticles. Nanoindentation and ellipsometry techniques evidenced that the insertion of Nb in the TiO2 matrix caused an increase in density and hardness (~ 18%) values and a reduction in the root mean square (RMS) values (30 and 75% of reduction for 3% and 1% Nb/TiO2). Nb-doped TiO2 thin films showed better performance in the photodegradation of methylene blue, reaching a degradation rate of 44% after 4 h of testing, against 26% for pure TiO2 thin film. The reaction rate was almost twice as high for the doped thin film, with a half-life time of 285 min versus 529 min for pure TiO2 film.Graphic abstract
What problem does this paper attempt to address?