Abstract:Glassy ribbons of Pd–Si alloys were prepared by a combination of melt spinning and flux treatment. The crystallization behaviour of a Pd81Si19 glassy alloy was studied through isothermal annealing at temperatures ranging lower than the glass-transition temperature T g to around the onset of crystallization. The evolution of microstructures arising from isothermal annealing was investigated by X-ray diffraction (XRD) and (high-resolution) transmission electron microscopy ((HR)TEM). XRD spectra showed that, after the sample was annealed at a sub-T g temperature, its first diffraction peak was split into two overlapping broad peaks. TEM analysis revealed the formation of a spherical, particle-like glassy phase embedded in the glassy matrix together with a finely connected network morphology within both. Combining these observations with compositional analysis suggested that phase separation had taken place during sub-T g annealing. When the glassy alloy was annealed at temperatures higher than T g, nanocrystalline structures, composed of Pd3Si and Pd phases plus a Pd9Si2 phase with a lamellar structure, was formed.

Pd-Si binary bulk metallic glass

Pd-Si Binary Bulk Metallic Glass Prepared at Low Cooling Rate

Formation and Mechanical Properties of Pd-Si Binary Bulk Metallic Glasses

Preparation and Thermal Stability of Pd 40.5 Ni 40.5 Si X P 19− X Bulk Metallic Glasses

Thermal stability and fragility of Pd–Si binary bulk metallic glasses

Structural heterogeneity in a binary Pd–Si metallic glass

Formation of Pd-Ni Based Bulk Metallic Glasses

Preparation and Thermal Stability of Pd_(77.5)Cu_6Si_(16.5) Bulk Metallic Glass

Preparation of a Pd-Cu-Si Bulk Metallic Glass with a Diameter Up to 11 Mm

Superductile Bulk Metallic Glass

Microstructural Features of Phase Transformation in a Binary Pd–Si Metallic Glass

Influence of Flux Treatment on the Glass Forming Ability of Pd-Si Binary Alloys

Investigation of A Ductile and Corrosion-Resistant Pd79au1.5ag3si16.5 Bulk Metallic Glass

Glass-forming ability and thermoplastic formability of a Pd 40 Ni 40 Si 4 P 16 glassy alloy

The Effect of Purification on the Glass-Forming Ability of a Pd-Cu-Si Alloy

The Influence of Cooling Rate on the Hardness of Pd–Si Binary Glassy Alloys

Glass Formation in the Pd–Si-based Alloys

Electronic structure of Pd-based bulk metallic glasses

Influence of minor Si addition on the glass-forming ability and mechanical properties of Pd40Ni40P20 alloy

Atomic Structure Changes and Phase Transformation Behavior in Pd–Si Bulk Glass-Forming Alloy

Glass Forming Ability of the Mo-Pd System Studied by Thermodynamic Modeling and Ion Beam Mixing