Abstract:This study examined the effect of the cooling rate on the hardness and its effect on the microstructure during porcelain firing simulation of a Pd-Ag-In-Sn-Ga metal-ceramic alloy. In practice, after each firing step for porcelain bonding, the prosthesis is cooled to room temperature before proceeding to the next firing step. The cooling step is known to allow the hardness of the metal substructure to increase. The aim of the study was to determine whether controlling the cooling rate after each porcelain-firing step increases the hardness of the Pd-Ag-based metal-ceramic alloy. The results showed that the hardness of specimens cooled at a higher cooling rate increased after each firing step compared to specimens cooled at a lower cooling rate (p < 0.05). During cooling after the firing simulation the InPd3-based phase of tetragonal structure precipitated from the Pd-Ag-rich matrix of the face-centered cubic structure. Hardening by cooling at a higher cooling rate after firing was the result of the coherency strains that formed at the interface of the Pd-Ag-rich matrix and the metastable phase based on the InPd3 phase. . The reduced hardness obtained in the specimen cooled at a lower cooling rate after firing resulted from the loss of coherency strains as the fine metastable phases based on the InPd3 phase were transformed into the coarser stable phase with decreased (c/a) of 0.88. This finding revealed that controlling the cooling rate during porcelain firing simulation improves the hardness of the Pd-Ag-In-Sn-Ga metal-ceramic alloy without an additional heat treatment of the alloy.

The Influence of Cooling Rate on the Hardness of Pd–Si Binary Glassy Alloys

Influence of quenching rate on the crystallization behaviors of Mg63Ni22Pr15 metallic glass

Effects Of The Cooling Rate On The Plasticity Of Pd40.5ni40.5p19 Bulk Metallic Glasses

Effects of the Cooling Rate on the Plasticity of Pd 40.5 Ni 40.5 P 19 Bulk Metallic Glasses

Pd-Si Binary Bulk Metallic Glass Prepared at Low Cooling Rate

Cooling-rate Dependence of the Density Ofpd40ni10cu

Structural heterogeneity in a binary Pd–Si metallic glass

Influence of minor Si addition on the glass-forming ability and mechanical properties of Pd40Ni40P20 alloy

Influence of Flux Treatment on the Glass Forming Ability of Pd-Si Binary Alloys

Critical Cooling Rate and Thermal Stability for a Ti–Zr–Ni–Cu–Be Metallic Glass

Effect of cooling rate on hardness and microstructure of Pd-Ag-In-Sn-Ga alloy during porcelain firing simulation

Effects of Rapid Cooling Rate on Microstructure Formation and Microhardness of Binary Ti-44Al Alloy

Microstructural Features of Phase Transformation in a Binary Pd–Si Metallic Glass

Glass-forming ability and thermoplastic formability of a Pd 40 Ni 40 Si 4 P 16 glassy alloy

Thermal stability and fragility of Pd–Si binary bulk metallic glasses

On the Glass-Forming Ability of Ni–P Binary Alloys

Cooling Rate Effect of Nanomechanical Response for A Ti-Based Bulk Metallic Glass

Pd-Si binary bulk metallic glass

Glass Formation in the Pd–Si-based Alloys

Microstructure and nanohardness of Ti-48%Al alloy prepared by rapid solidification under different cooling rates

Effects of cooling rate and sub-Tg annealing on Ni80P20 metallic glass: A molecular dynamic (MD) study