Abstract:Ultrafine grained (UFG) metallic materials arouse a great interest clue to their excellent mechanical properties. The UFG materials, produced by severe plastic deformation (SPD) technique such as channel angular pressing (ECAP) and high pressure torsion (HPT), exhibit obvious improvement in strength but a large decrease in their thermal stability and ductility. In this article; an UFG QBel.7 copper alloy with good comprehensive properties was prepared by multi directional compression (MDC) at room temperature and subsequent annealing at high temperature. The deformed and subsequent annealed microstructures were investigated by OM, TEM and SEM/EBSD techniques. The integrated flow curves plotted over a number of compression passes increase to a. maximum at moderate strains of 1 to 2 followed by steady state like flow at high cumulative strains. Fine grains were not observed even at a higher cumulative stain of Sigma epsilon=4.8, although there were many sub grains when the samples were deformed to Sigma epsilon=2.4. This indicates that the dynamic recrystallization or recovery was completely inhibited by Fine precipitates. Static recrystallization (SRX) of the MDCed structure at 973 K was also investigated. With the increment of cumulative strains, the effect of grain refinement became more obvious, but the thermal stability was getting worse. At a medium strain of Sigma epsilon=2.4, the minimal grain size of 0.8 mu m could be developed with an excellent combination of properties. The formation of ultrafine grains is attributed to the development from low angle boundaries to medium angle boundaries to large angle boundaries. The change of the average grain size with annealing time could be divided into three, stages: a recovery period for grain refinement, rapid grain refinement and normal grain growth.

Friction-assisted pulse electrodeposition of high-performance ultrafine-grained Cu deposits

High-speed electrodeposition of bright Cu with excellent mechanical properties utilizing friction of hard particles

Ultra-high flatness and conductivity of copper electrodeposits obtained by nano-twinned/fine-grained double layer electrodeposition

Surface morphology and crystal orientation of electrodeposited tungsten coatings with different pulse parameters

Microstructure evolution and anti-wear mechanism of Cu film fabricated by magnetron sputtering deposition

Preparation of highly (111) textured nanotwinned copper by medium-frequency pulsed electrodeposition in an additive-free electrolyte

Effect of ultrasonic field on the mechanism of electrodeposited Cunucleation and growth

Microstructural evolution of pure copper subjected to friction sliding deformation at room temperature

Strategies to Achieve High Strength and Ductility of Pulsed Electrodeposited Nanocrystalline Co-Cu by Tuning the Deposition Parameters

Improving Adhesion Strength and Electrical Conductivity of Cold-Sprayed Al Deposit on Cu Substrate Through Friction-Stir-Processing

Microstructure and fretting wear behaviour of gradient-structured Cu sheets prepared by plastic flow machining

Effects of Normal Stress, Surface Roughness, and Initial Grain Size on the Microstructure of Copper Subjected to Platen Friction Sliding Deformation

Fabrication of Pyramid-Like Structured Cu Coatings by Pulse-Reverse Current Electrodeposition

A New Approach to Prepare Fully Dense Cu with High Conductivities and Anti-Corrosion Performance by Cold Spray

Electrodeposition of Copper with Ultra-large Grains and Good Conductivity

Effect of additives on the microstructure and properties of pulsed electrodeposited copper foils

Enhancing performance of electrical discharge machining by ultrafine-grained Cu-0.5%Cr electrode

Preparation of Ultrafine-Grained Copper Alloy by Annealing Treatment after Multi-Directional Compression

Preparation of Cu Nanolayers by Magnetic Field-Assisted Electrodeposition and Research on the Nucleation and Growth Mechanism

Microstructure and Mechanical Properties of Ultrafine-Grained Copper by Accumulative Roll Bonding and Subsequent Annealing

Effect of Pulse Frequency on the One-Step Preparation of Superhydrophobic Surface by Pulse Electrodeposition