Abstract:Abstract Ultra-thin ALD-TaN/PVD-Ta liners have been developed to prevent Cu diffusion into porous interlayer dielectric (ILD) materials envisioned for future copper interconnections. The porous ultra-low k (p-ULK) film is prepared using the spin-on method, and typical k-value and the average pore size of p-ULK used in this paper are 2.3 and 2-3 nm, respectively. Interaction and phenomena at the ILD/ALD-TaN interface have been investigated, and the electrical measurements of samples with a bi-layered ALD-TaN/PVD-Ta barrier were performed after completing the metallization and CMP process. A deep penetration of ALD-TaN was observed on the as-deposited p-ULK, which is due to the interconnected pore structures. However, the surface of the p-ULK is drastically changed after the etch process, where changes are attributed to plasma damage and re-deposition of etched species. Pores can therefore be sealed during the etch process. Furthermore, the plasma damage makes the sidewall more hydrophilic, which may promote the growth of ALD-TaN layer. Based on EELS and EDS profiles, there is no signature of TaN penetration into the etched p-ULK at M1 level with a sharp Ta peak, which indicates excellent stability of ultra-thin ALD-TaN liner. An oxidation test in air ambient and at elevated temperature confirmed the barrier properties of the stacked ALD-TaN/PVD-Ta layers. Any weak point in the barrier allows the Cu to oxidize and to make a color change under an optical microscope. However, all of our samples showed no color change, which implies that the barrier is very uniform and stable. Electrical properties measured at M1 showed excellent results. Our results demonstrate the ability to successfully integrate ALD-TaN barriers with a nanoporous ULK film.

Ultrathin Diffusion Barriers/Liners for Gigascale Copper Metallization

Recent Advances in Barrier Layer of Cu Interconnects

CVD-Mn/CVD-Ru-based barrier/liner solution for advanced BEOL Cu/Low-k interconnects

Reliability Studies of Barrier Layers for Cu/PAE Low-K Interconnects.

Enhancing Interconnect Reliability and Performance by Converting Tantalum to 2D Layered Tantalum Sulfide at Low Temperature

Ultrathin graphene and graphene oxide layers as a diffusion barrier for advanced Cu metallization

Integration of ALD-TaN Liners on Nanoporous Dielectrics

Studies of two-dimensional h-BN and MoS2 for potential diffusion barrier application in copper interconnect technology

Two-Dimensional h-BN and MoS2 as Diffusion Barriers for Ultra-Scaled Copper Interconnects

Ti and NiPt/Ti Liner Silicide Contacts for Advanced Technologies

Selecting Alternative Metals for Advanced Interconnects

Comparison of the Time-Dependent Physical Processes in the Electromigration of Deep Submicron Copper and Aluminum Interconnects

A Comprehensive study of reliability improvement for 65nm Cu/Low-k process

Novel Copper Filling Methods for 2 Μm × 20 Μm TSVs with an Electroless Deposited Co or Atomic Layer Deposited Ru Seed Layer

Understanding the Impact of Surface Engineering, Structure, and Design on Electromigration Through Monte Carlo Simulation and In‐Situ SEM Studies

Understanding electromigration failure behaviors of narrow cobalt lines and the mechanism of reliability enhancement for extremely dilute alloying of manganese oxide

Improved Barrier Properties of Ultrathin Ru Film with Tan Interlayer for Copper Metallization

Ultra-Thin Ru/TaN Bi-Layer as Diffusion Barrier to Seedless Copper Interconnect

Voidless metal filling and elimination of metal diffusion in PVD barrier and seed process for high performance Cu interconnect

Electrochemical processes for the production of copper interconnects on non-metallic barrier layers

Copper Bonding Technology in Heterogeneous Integration