Abstract:Carbon nanotubes (CNTs) can be locally grown on custom-designed CMOS microheaters by a thermal chemical vapour deposition (CVD) process to utilize the sensing capabilities of CNTs in emerging micro- and nanotechnology applications. For such a direct CMOS-CNT integration, a key requirement is the development of necessary post-processing steps on CMOS chips for fabricating CMOS-MEMS polysilicon heaters that can locally generate the required CNT synthesis temperatures (~650–900 °C). In our post-CMOS processing, a subtractive fabrication technique is used for micromachining the polysilicon heaters, where the passivation layers in CMOS are used as masks to protect the electronics. For dielectric etching, it is necessary to achieve high selectivity, uniform etching and a good etch rate to fully expose the polysilicon layers without causing damage. We achieved successful post-CMOS processing by developing two-step reactive ion etching (RIE) of the SiO 2 dielectric layer and making design improvements to a second-generation CMOS chip. After the dry etching process, CMOS-MEMS microheaters are partially suspended by SiO 2 wet etching with minimum damage to the exposed aluminium layers, to obtain high thermal isolation. The fabricated microheaters are then successfully utilized for synthesizing CNTs by a local thermal CVD process. The CMOS post-processing challenges and design aspects to fabricate CMOS-MEMS polysilicon microheaters for such high-temperature applications are detailed in this article. Our developed process for heterogeneous monolithic integration of CMOS-CNT shows promise for wafer-level manufacturing of CNT-based sensors by incorporating additional steps in an already existing foundry CMOS process.

Fabrication of Planar Heating Chuck Using Nichrome Thin Film as Heating Element for PECVD Equipment

Electrochemical Deposition of Pure-Nickel Microstructures with Controllable Size

Fabrication of Nickel and Nickel Carbide Thin Films by Pulsed Chemical Vapor Deposition

Design of a Hot Plate with Rapid Cooling Capability for Thermal Nanoimprint Lithography

Process kit and wafer temperature effects on dielectric etch rate and uniformity of electrostatic chuck

Post-CMOS processing challenges and design developments of CMOS-MEMS microheaters for local CNT synthesis

Simulation of Flow and Thermal Field in a PECVD Reaction Chamber

Investigating the Planarization of Al0.5CoCrFeNi2 High-Entropy Thin Films Through Chemical Mechanical Polishing

Fabrication of a high aspect ratio thick silicon wafer mold and electroplating using flipchip bonding for MEMS applications

Fabrication and test of PECVD SiC resonator

A New Method of Making Thin-Film Thermocouples at Sharp Surfaces of Aero-engine Hot Component

Energetic characterization during plasma electrolytic polishing of cemented tungsten carbide

Fabrication of Ultramicroelectrodes Based on PECVD

Electrical Properties of Micro-Heaters Using Sputtered NiCr Thin Film

Al doped poly-Si micro-heater for thermomechanical fabrication of micro/nano structure

Experimental study on nanofludic heat pipe hot chuck plate in semiconductor wafer baking process

Processing and Characterisation of PECVD Silicon Nitride Films

A New Approach of Electrochemical Etching Fabrication Based on Drop-off-delay Control

Multiple Preheating Processes for Suppressing Liquefaction Cracks in IN738LC Superalloy Fabricated by Electron Beam Powder Bed Fusion (EB-PBF)

Inductively Coupled Plasma Etching of Bulk Tungsten for MEMS Applications

Fabrication Technology and Investigation of Silicon-based Tool Electrodes for Micro ECM