Abstract:Carbon nanotubes (CNTs) can be locally grown on custom-designed CMOS microheaters by a thermal chemical vapour deposition (CVD) process to utilize the sensing capabilities of CNTs in emerging micro- and nanotechnology applications. For such a direct CMOS-CNT integration, a key requirement is the development of necessary post-processing steps on CMOS chips for fabricating CMOS-MEMS polysilicon heaters that can locally generate the required CNT synthesis temperatures (~650–900 °C). In our post-CMOS processing, a subtractive fabrication technique is used for micromachining the polysilicon heaters, where the passivation layers in CMOS are used as masks to protect the electronics. For dielectric etching, it is necessary to achieve high selectivity, uniform etching and a good etch rate to fully expose the polysilicon layers without causing damage. We achieved successful post-CMOS processing by developing two-step reactive ion etching (RIE) of the SiO 2 dielectric layer and making design improvements to a second-generation CMOS chip. After the dry etching process, CMOS-MEMS microheaters are partially suspended by SiO 2 wet etching with minimum damage to the exposed aluminium layers, to obtain high thermal isolation. The fabricated microheaters are then successfully utilized for synthesizing CNTs by a local thermal CVD process. The CMOS post-processing challenges and design aspects to fabricate CMOS-MEMS polysilicon microheaters for such high-temperature applications are detailed in this article. Our developed process for heterogeneous monolithic integration of CMOS-CNT shows promise for wafer-level manufacturing of CNT-based sensors by incorporating additional steps in an already existing foundry CMOS process.

Post-CMOS processing challenges and design developments of CMOS-MEMS microheaters for local CNT synthesis

Design and Fabrication of CMOS Microstructures to Locally Synthesize Carbon Nanotubes for Gas Sensing

Monolithic Three‐dimensional Integration of Aligned Carbon Nanotube Transistors for High‐performance Integrated Circuits

Post-CMOS Wafer Level Growth of Carbon Nanotubes for Low-Cost Microsensors—a Proof of Concept

Localized Growth of Carbon Nanotubes on CMOS Substrate at Room Temperature Using Maskless Post-CMOS Processing

An On‐Chip SiC MEMS Device with Integrated Heating, Sensing, and Microfluidic Cooling Systems

Microheater Chips with Carbon Nanotube Resistors

Fabrication of monolithic integrated bimaterial resonant uncooled IR sensor

Process Development for CMOS-MEMS Sensors with Robust Electrically Isolated Bulk Silicon Microstructures

Post-CMOS Process for High-Aspect-ratio Monolithically Integrated Single Crystal Silicon Microstructures

Metal-catalyst Free Integration of SiO2 Nanowires into Carbon MEMS

Novel design and characterisation of SOI CMOS micro-hotplates for high temperature gas sensors

Study on Compatible CMOS-MEMS Process with Surface Micromachining for the Application of Monolithic Integration

Integration of PDMS-infiltrated CNTs and Si bulk-micromachining for monolithic physical sensors application

On-Chip Hotplate for Temperature Control of Cmos Saw Resonators

Synthesis of Vertical Carbon Nanotube Interconnect Structures Using CMOS-Compatible Catalysts

A CMOS Compatible Process for Monolithic Integration of High-Aspect-ratio Bulk Silicon Microstructures

Fabrication of SiCN MEMS by photopolymerization of pre-ceramic polymer

Investigation and Modeling of Etching Through Silicon Carbide Vias (TSiCV) for SiC Interposer and Deep SiC Etching for Harsh Environment MEMS by DoE

Multilevel silicide interconnect in monolithic microsensors