Abstract:This study presents a process design methodology to improve the performance of a CMOS-MEMS gap-closing capacitive sensor. In addition to the standard CMOS process, the metal wet-etching approach is employed as the post-CMOS process to realize the present design. The dielectric layers of the CMOS process are exploited to form the main micro mechanical structures of the sensor. The metal layers of the CMOS process are used as the sensing electrodes and sacrificial layers. The advantages of the sensor design are as follows: (1) the parasitic capacitance is significantly reduced by the dielectric structure, (2) in-plane and out-of-plane sensing gaps can be reduced to increase the sensitivity, and (3) plate-type instead of comb-type out-of-plane sensing electrodes are available to increase the sensing electrode area. To demonstrate the feasibility of the present design, a three-axis capacitive CMOS-MEMS accelerometers chip is implemented and characterized. Measurements show that the sensitivities of accelerometers reach 11.5 mV G−1 (in the X-, Y-axes) and 7.8 mV G−1 (in the Z-axis), respectively, which are nearly one order larger than existing designs. Moreover, the detection of 10 mG excitation using the three-axis accelerometer is demonstrated for both in-plane and out-of-plane directions.

Study on Compatible CMOS-MEMS Process with Surface Micromachining for the Application of Monolithic Integration

Study on Compatible Cmos-Mems Process with Surface Micromachining for the Application of Monolithic Integration

A CMOS Compatible Process for Monolithic Integration of High-Aspect-ratio Bulk Silicon Microstructures

Process-induced stress and hydrogen effects on monolithic integrated BiCMOS-MEMS resonators

Study on New Method of MEMS Monolithic Integration and Its Key Technology

Process-Induced Stress and Hydrogen Effects on Monolithic Integrated CMOS-MEMS Micro-Bimaterial Cantilever Sensor Array

Inter-CMOS process for monolithic integrated MEMS resonator

Post-CMOS Process for High-Aspect-ratio Monolithically Integrated Single Crystal Silicon Microstructures

CMOS MEMS: A Key Technology Towards the &#x201c;more Than Moore&#x201D; Era

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

MEMS monolithic integration technology

A molded surface-micromachining and bulk etching release (MOSBE) fabrication platform on (1 1 1) Si for MOEMS

12 inch MEMS process for sensors implementation and integration

Microdevice Array Design and Fabrication in Monolithic MEMS SoC

IC Simulations of the On-chip Integration for SOI CMOS and MEMS

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors

Monolithic Integration Of Micro-Cantilever With Conditioning Circuits Based On Soi Techniques

Monolithic Integration Of A Micromachined Flow Sensor Based On Post-Cmos

A new process for releasing micromechanical structures in surface micromachining with polysilicon support and LPCVD Si3N4 embedded mask

Monolithic integration of micromachined sensors and CMOS circuits based on SOI technologies

Three-dimensional integration of suspended single-crystalline silicon MEMS arrays with CMOS