Abstract:In the last few years, demand for hot stamped components has increased in the automotive industry. Determination of formability under hot stamping is challenging due to elevated temperature, fast cooling, and high punch velocity. Although there was various strive for formability determination, but there were limitations with experiments like non-uniform heating of specimen, non-uniform strain, and temperature distribution. Therefore, in this work, an experimental apparatus was developed to determine formability at room temperature, high temperature, hot stamping conditions, and any complex process cycle involving heating and cooling. New specimen was designed to produce different strain paths, uniform, and homogenous temperature distribution with the help of FEM software using thermomechanical and thermoelectrical simulation. A micro hemispherical dome-based experimental apparatus was designed using Solidworks. The designed apparatus was used in conjunction with the thermo-mechanical simulator (Gleeble-3800). Thermomechanical analysis was done in PAM STAMP software to optimize specimen size and shape to get uniform strain distribution and different strain paths. A thermoelectric FEM model was developed using Abaqus 6.14 to optimize the temperature distribution in the specimen. The developed model enables choosing the appropriate polarity of the electrical cable connection to achieve uniform temperature distribution in the specimen. Strain path and temperature profiles for experiment and simulation were compared. Further, a forming limit curve was developed using the designed apparatus to verify the feasibility of the apparatus. For feasibility test of apparatus, hot stamping process was selected. This new design apparatus can be used for a range of temperatures up to 1000 °C, hot stamping conditions, and for different materials (aluminum, magnesium alloys, different grade of steel, etc.). It concludes that the connection of different polarities of electrical cable was critical for homogenous and uniform temperature distribution in specimens.

Design of a Hot Plate with Rapid Cooling Capability for Thermal Nanoimprint Lithography

Advanced ice lithography system using a micro-machined Joule-Thomson cooler

Optimization of Control Parameters in Micro Hot Embossing

Replication of large‐area microstructures by combining movable induction heating and roller hot embossing

Research on Heat Transfer for Hot Embossing of Polymeric Microfluidic Chips

Experimental Study on the Fabrication of the Light Guide Plate with Hot Embossing Method

A Rapid Thermal Nanoimprint Apparatus Through Induction Heating Of Nickel Mold

Axisymmetric thermo-mechanical analysis of laser-driven non-contact transfer printing

Experimental Study on the Hot Embossing Polymer Microfluidic Chip

Development of Estimation Procedure of Contact Heat Transfer Coefficient at the Part–Tool Interface in Hot Stamping Process

Research on Optimization of the Hot Embossing Process

Thermo-mechanical Modeling of Laser-Driven Non-Contact Transfer Printing: Two-Dimensional Analysis

Six-DOF Microstage Thermal Analysis and Cooler Design

Development of a Reliable Micro-Hotplate with Low Power Consumption

A Comparative Numerical Analysis of Cold Plates for Thermal Management of Chips With Hotspots

Embedded Micro-Pin Fin Heat Sink of Two-Phase Liquid Cooling for High Heat Flux 3D ICs

Design and development of a micro-LDH apparatus to determine formability of sheet metal under hot stamping conditions using Gleeble

The Investigation of the Silicon Fabricated Balanced Shunt Micro Pin Fins Cold Plate for High Heat Flux Devices

Optimization of Embedded Cooling for Hotspots Based on Compound Plate Thermal Spreading Model

Hot Embossing and Thermal Bonding of Poly(methyl Methacrylate) Microfluidic Chips Using Positive Temperature Coefficient Ceramic Heater

An efficient plate heater with uniform surface temperature engineered with effective thermal materials