Abstract:Radiative properties are critical to quantify radiative energy fluxes between surfaces and in participating media. However, there is limited experimental data on temperature-dependent radiative properties of materials. This work focuses on experimentally measuring temperature-dependent diffuse reflectance in the near- and mid-infrared spectra (1–20 μm) for ceramic particles with applications as heat-transfer and thermal-storage media in concentrated solar power (CSP) plants. Specifically, a commercially available sintered bauxite proppant, ACCUCAST ID80, and its primary chemical constituents—alumina (Al2O3) and silica (SiO2)—are measured in powder form using a Fourier transform infrared spectrometer (FTIR) coupled with a specialized diffuse reflectance accessory and a heated stage. Room-temperature diffuse reflectance measurements show increased absorption in tests with greater mass fractions of the ceramic samples. There is a strong correlation in the measured reflectance spectra of ACCUCAST with alumina and silica in the spectral range 2000–500 cm−1 (5–20 μm). Whereas, for shorter wavelengths (<5μm), the absorptance for ACCUCAST is greater than the absorptance for alumina and silica, indicating contributions from other chemical species present in the composite material. For the first time, temperature-dependent diffuse reflectance measurements are reported for ACCUCAST up to 1000 °C. These results are compared against those of alumina and silica through the calculation of a thermal emittance. All three materials exhibit a calculated emittance of ∼0.9 at room temperature. However, this value decreases to ∼0.6 for ACCUCAST and drops to less than 0.4 for alumina and silica at 1000 °C. Thermal cycling in air at 1000 °C resulted in a visible color change from dark grey to light orange for ACCUCAST and a subsequent larger increase in reflectance for wavelengths less than 5 μm as compared to ACCUCAST thermally cycled at 1000 °C in vacuum. Alumina and silica spectra proved to be largely unaffected by thermal cycling under atmospheric conditions. Overall, this study establishes a powerful technique for the characterization of radiative properties of particulate materials as a function of temperature and presents a detailed case study of ACCUCAST, a candidate for next-generation particle-based CSP.

Thermal Conductivity: V, High‐Temperature Method and Results for Alumina, Magnesia, and Beryllia from 1000° to 1800°C

Predictions and Measurements of Thermal Conductivity of Ceramic Materials at High Temperature

High Temperature Thermal Physical Properties of High-Alumina Fibrous Insulation

Investigation of the thermal expansion of the refractory materials at high temperatures

Application of the van der Pauw method for electrical conductivity measurements at high temperatures using an insulating compressing ring

Thermal Conductivity of the Rare-Earth Strontium Aluminates

Thermal Conductivity of the New Candidate Materials for Thermal Barrier Coatings

Accurate prediction of thermal conductivity of Al2O3 at ultrahigh temperatures

An Experimental Study of Effective Thermal Conductivity of High Temperature Insulations

Mechanical and Thermal Properties of 99% and 92% Alumina at Cryogenic Temperatures

Temperature-dependent diffuse reflectance measurements of ceramic powders in the near- and mid-infrared spectra

Experimental Investigation of High Temperature Thermal Contact Resistance of Thin Disk Samples Using Infrared Camera in Vacuum Condition

Precision measurements of the thermal conductivity, electrical resistivity, and Seebeck coefficient from 80 to 400 K and their application to pure molybdenum

Direct measurements of thermal transport in glass and ceramic microspheres embedded in an epoxy matrix

Exploring the increasing behavior of thermal conductivity for high-entropy zirconates at high temperatures

Measurement of Melting Point, Normal Spectral Emittance (at Melting Point) and Electrical Resistivity (Near Melting Point) of Some Refractory Alloys

Experimental investigation on thermal contact resistance of alumina fibrous insulation material with Ti-6Al-4V alloy at high temperature and its effective thermal conductivity

Research of Mechanical and Thermal Properties of Al2O3 at Cryogenic Temperatures

Searching for low thermal conductivity materials for thermal barrier coatings: A theoretical approach

Measurement of High-Temperature Spectral Emissivity Using Integral Blackbody Approach

Simultaneous measurement of normal spectral emissivity and temperature of materials with low thermal conductivity