Abstract:Despite more than seven decades of active research and development in thermoelectricity, the accurate measurement of the thermoelectric (TE) properties of bulk materials has remained a challenge, mainly because of the strong interrelation between thermal and electrical phenomena. This work highlights practical advancements in methods and instrumentation dedicated to the simultaneous measurements of TE properties such as the Seebeck coefficient (S), the thermal (κ), and electrical (σ) conductivities and the dimensionless TE figure of merit ZT = S2σT/κ. The accuracy of a Harman based approach, as implemented by the ZT-Scanner (TEMTE Inc.), applicable to the simultaneous measurement of the above TE properties, has been made possible by a self-contained calibration procedure, which is based on the availability of two samples of the same homogeneous material having different shape factors. It is of practical importance that this approach provides a simple procedure to obtain the calibration for the figure of merit ZT and the thermal conductivity in the temperature interval from 300 to 720 K. In addition, we show that a simplified Harman setup with no thermocouples attached to the sample can also be used for self-contained calibrated ZT measurements. It is concluded that the implemented steady-state approach decreases the relative error down to 1%–2% for ZT measurements and can be recommended for most applications not involving dynamical behavior. In particular, it is proposed that self-generated calibration samples can critically increase the quality and ease of comparison of TE measurements if they are adopted by the TE community.

Precision measurements of the thermal conductivity, electrical resistivity, and Seebeck coefficient from 80 to 400 K and their application to pure molybdenum

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

Precise measurement of absolute Seebeck coefficient from Thomson effect using ac-dc technique

A Setup for Measuring the Seebeck Coefficient and the Electrical Resistivity of Bulk Thermoelectric Materials

High-Temperature Measurement of Seebeck Coefficient and Electrical Conductivity

A high-precision method to measure thermal conductivity of solids using reversible heat flux

Measuring the thermal conductivity and interfacial thermal resistance of suspended MoS2 using electron beam self-heating technique

High temperature setup for measurement of Hall coefficient and electrical conductivity of thermoelectric materials

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

Self-contained calibration samples and measurements of the thermoelectric figure of merit: A method to improve accuracy

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance

Apparatus for the room temperature measurement of low field Nernst and magneto-Seebeck coefficients

A High-Precision Instrumentation of Measuring Thermal Contact Resistance Using Reversible Heat Flux

Electrical Conductivity Relaxation Measurements: Application of Low Thermal Mass Heater Stick

Measurement Of The Thermal Conductivities Of Suspended Mos2 And Mose2 By Nanosecond Et-Raman Without Temperature Calibration And Laser Absorption Evaluation

A Micromachined Device Using Transient Hot-Wire Method For High Accuracy Thermal Conductivity Measurement Of Semi-Rigid Materials

A hot probe setup for the measurement of Seebeck coefficient of thin wires and thin films using integral method

Frequency-resolved Raman Thermometry Analysis via a Multi-layer Heat Transfer Model for Bulk and Low-dimensional Materials

Simultaneous thermal conductivity and specific heat measurements of thin samples by transient Joule self-heating

Accurate Measurements of Thermal Conductivity and Thermal Diffusivity of Molten Carbonates